Advertisement
4.3.
BATTERY NOT CONNECTED TO A VEHICLE
4.3.1.
Connect the (+) red clamp to the positive (+) battery post and connect the (-) black clamp to the negative (-) battery post.
4.4.
CONNECT CHARGER TO MAINS POWER SUPPLY.
4.4.1.
Plug the charger into the power supply and switch on. The ammeter gauge (fig.1) on the front of the charger will indicate state of
charging or fault. If the pointer points to the clear battery symbol, the unit will require charging. If it points to the black symbol, it is fully
charged.
4.4.2.
While the ammeter pointer is pointing to the clear battery symbol, the unit is supplying a high charge rate. If the pointer is pointing to
the black battery a low charge rate is being supplied.
4.4.3.
Stop charging at any time by disconnecting the mains cable from the wall socket.
5. MAINTENANCE
5.1.
After each use, clean the battery charger clamps. Be sure
to remove any battery fluid that will cause corrosion of the
copper clamps.
5.2.
Clean the outside case of the charger with a soft cloth and,
if necessary, mild soap solution.
5.3.
Keep the charger cords loosely coiled during storage to
prevent damage to the cords.
DO NOT use the charger if cords or clamps have been damaged
8
in any way. If the power supply cord is damaged, it must be
replaced by the manufacturer, its service agent or qualified
person in order to avoid a hazard.
Parts support is available for this product. Please email sales@sealey.co.uk or telephone 01284 757500
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
Blade Fuse
On underside
Fig.1
www.sealey.co.uk
DSBC4, DSBC6
Ammeter
Gauge
On (1)
Off (0)
Issue 1
25/02/21
Advertisement
