Optoma HD146X User Manual page 33

USING THE PROJECTOR
Gamma
Set up gamma curve type. After the initial setup and fine tuning is completed, utilize the Gamma Adjustment steps
to optimize your image output.
‡ Film: For home theater.
‡ Video: For video or TV source.
‡ Graphics: For PC / Photo source.
‡ Standard(2.2): For standardized setting.
‡ 1.8 / 2.0 / 2.4: For specific PC / Photo source.
Color Settings
Configure the color settings.
‡
BrilliantColor
enable higher brightness while providing true, more vibrant colors in picture.
‡ Color Temperature: Select a color temperature from Warm, Standard, Cool, or Cold.
‡ Color Matching: Select the following options:
Color: Adjust the red (R), green (G), black (B), cyan (C), yellow (Y), magenta (M), and white (W)
±
level of the image.
Hue / R(red)*: Adjust the color balance of red and green.
±
Notee:
Saturation / G(green)*: Adjust a video image from black and white to fully saturated color.
±
Notee:
Gain / B(blue)*: Adjust the image brightness.
±
Notee:
Reset: Return the factory default settings for color matching.
±
Exit: Exit the "Color Matching" menu.
±
‡ RGB Gain/Biase: This settings allows to configure the brightness (gain) and contrast (bias) of an
image.
Reset: Return the factory default settings for RGB gain/bias.
±
Exit: Exit the "RGB Gain/Bias" menu.
±
‡ Color Space (HDMI input): select an appropriate color matrix type from the following: Auto,
RGB(0-255), RGB(16-235), and YUV.
Dynamic Black
Use to automatically adjust the picture brightness to give optimum contrast performance.
Brightness Mode
Adjust the brightness mode settings for lamp-based projectors.
‡ Bright: Choose "Bright" to increase the brightness.
‡ Eco.: Choose "Eco." to dim the projector lamp which will lower power consumption and extend the
lamp life.
Reset
Return the factory default settings for color settings.
: This adjustable item utilizes a new color-processing algorithm and enhancements to
TM
*If the Color setting is set to white (W), you can adjust the red color setting.
*If the Color setting is set to white (W), you can adjust the green color setting.
*If the Color setting is set to white (W), you can adjust the blue color setting.
33
English