Nikon SF-210 Reference Manual page 28

Cautions
• The SF-210 does not function equally well with all types of slide mount. Use 35-mm slides
with mounts 1.0–3.2 mm thick and 49–50.8 mm wide. Other slides could cause the feeder
to jam.
• Slides with mounts that are heavily warped can cause the feeder to jam.
• Do not use mounts with peeling or burred edges, mounts to which seals or labels have been
affi xed, or mounts with uneven surfaces. Failure to observe this precaution could cause the
feeder to jam.
• Do not load slides into the feeder with the longer side of the aperture facing the scanner, as
this could damage the fi lm or slide mount or cause the feeder to jam. Insert slides as shown
by the insertion guide sticker next to the feed magazine.
Insertion
guide sticker
• Do not load slides in the feed magazine past the load mark, as this may cause the feeder to
jam.
• Do not move the scanner while scanning is in progress.
• Remove scanned slides from the ejection magazine before the magazine is full. Continuing
scanning when there is no room left in the ejection magazine could jam the feeder.
• Do not remove the feeder while scanning is in progress.
• Before turning the scanner off or removing the feeder, make sure that all slides have been
removed from the magazine and that the last slide to be fed has been ejected.
En-10
Warped slide mount
SF-210 (viewed
from above)
To scanner ⇒