Advertisement
Available languages
Available languages
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOTE: Battery packs should not be stored completely depleted
of charge. The battery pack will need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the
labels on the charger and the battery pack may show the
following pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
Charge D
WALT battery packs only with designated
e
D
WALT chargers. Charging battery packs other than
e
the designated D
WALT batteries with a D
e
charger may make them burst or lead to other
dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).
Battery Type
The DCS367 operates on 18 volt battery packs.
These battery packs may be used: DCB181, DCB182, DCB183,
DCB183B, DCB184, DCB184B, DCB185, DCB187, DCB189,
DCB546, DCB547, DCB548. Refer to Technical Data for
more information.
Package Contents
The package contains:
1 Cordless Reciprocating Saw
1 Li-Ion battery pack (P1-model)
2 Li-Ion battery packs (P2-model)
3 Li-Ion battery packs (P3-model)
1 Kitbox (P-models)
1 Charger (P-models)
1 Instruction manual
•
Check for damage to the tool, parts or accessories which may
have occurred during transport.
•
Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Date Code Position (Fig. A)
The date code
10
is printed into the housing.
Example:
Description (Fig. A)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
WALT
e
Trigger switch
1
Lock-off button
2
Blade clamp release lever
3
Shoe
4
Hand grip
5
Battery pack
6
Battery release button
7
Main handle
8
Worklight
9
Datecode
10
, which also includes the year of manufacture,
2019 XX XX
Year of Manufacture
EngLIsh
31
Advertisement
