Table of Contents
Advertisement
INSTALLATION / CONTROLLER
CONNECTION TO A MAIN DRAIN
NB: if installing a fish cabinet, please ensure that it is
connected to a main drain.
SHELF/SLIDE FITTING
When positioning slides on standard cabinets and
counters, present slide to racking by holding it in
the opposite hand to the side of the cabinet to that
which they are to be applied. Present slide at 45°
angle (figure 3). When in place, let slide drop into
position to create a horizontal ledge on which the
shelves will sit.
FIG 3.
Amber / Bottle Coolers are fitted with pilaster and
clips (figure 4) for fitting. Amber freezer models are
fitted with fixed shelves.
LOADING / SHELF DISTRIBUTION
Before loading, allow the appliance to reach its
normal operating temperature.
When loading the appliance, please ensure that its
load is equally distributed throughout and ensure air
can circulate around and through stored products.
Ensure all items are covered and that raw and
cooked foods are stored separately.
Care should be taken when loading the appliance.
Do not obstruct the air ducts. Take care of any parts
with possible sharp edges.
LOCKING FACILITY
On models with a locking facility, it is recommended
that the key be removed from its lock during normal
working use. This will prevent bending or breaking
of the key which could result in the lock having to be
replaced.
Removing the key will also prevent accidental
locking when the door is open. This will prevent the
door from closing properly and cause the interior
temperature to rise. If not checked in time, a loss of
food may result.
6
FIG 4.
OVERNIGHT OPERATION
Onyx / Raised Pan-holder Options / Salad Units
/ Thermowells/ Well Options
We recommend that users remove all food products
and place in suitable refrigerated storage overnight.
CONTROLLER
CONTROLLER / DISPLAY
The display should be checked daily to ensure that
the correct temperature is being maintained.
CONTROLLER - TYPE A
Switching on your Appliance
Switch the appliance on or off by pressing and
holding
for 3 seconds when it is in standby
mode (display shows "- - -").
Key to Controls
Compressor running indicator
Defrost indicator
Condenser cleaning light and switch
Evaporator fan running indicator
LED display (temperature/alarm)
Up and down adjustment/defrost instigation
Enter button
Standby switch
Door Alarm (Meat / Freezer upright Models
only)
If the door has been left open for 5 minutes or
longer then the cabinet will emit an audible alarm
and 'AL' will flash in the display window. Press any
button to acknowledge the alarm. The alarm will
mute and 'do' will appear in the window. Shut the
door and the alarm will cease. However the visual
alarm continues if the door switch has a malfunction
or if there is another fault. The window will show a
different display - call a Service Engineer.
Advertisement
Table of Contents
