Related Manuals for Transmitter Solutions iGAZER50LR
Summary of Contents for Transmitter Solutions iGAZER50LR
- Page 1 RoHS 5002680 iGAZER50LR-10K/NC LONG RANGE PHOTO EYES Retro-Reflective & Long Range Type INSTRUCTIONAL MANUAL Specifications Features & Applications Mounting the Sensor Wiring...
-
Page 3: Specifications
Specifications Input Volt. 12-30 VDC/AC 60 Hz (Non Polarity) Current consumption 100 mA Tx LED Element Infrared LED/Wave length 740 nm Beam Spreading angle 5˚ Contact Capacity 30VDC/AC, 0.5A Response Time 10 msec Delay Time of Relay 10 msec Sensing Range 10 meters LED Indicators: Red LED Off: Beam aligned / Red LED On: Beam broken... -
Page 4: Features And Applications
Features & Applications FEATURES: • Long Range Photo Eye • Retro-reflective • Infrared LED element • IP-55 water proof/cable gland • PC casing, anti fog/dew/rains • Round shape reflector-Dia.: 82.1mm • Input Volt.: 12-30V DC/AC 60 Hz (Non Polarity) • Twin colors led indicator for beam alignment •... -
Page 5: Mounting The Sensor
Mounting the Sensor 1. Unscrew the 4 screws and remove the cover. 2. Loosen the captive screw to free the sensor from the mounting plate. 3. Using the included screws, mount the mounting plate to the wall. 4. Use the breakout and cable gland at the bottom of the sensor to run the wires. - Page 6 Wiring Break down & remove plastic pack Please use screwdriver & hammer to break plastic pack down and remove pack . Then insert the cable gland into the empty hole. (See diagram 2) Install the cable gland Knob Screw the knob with the nut till fixed.
- Page 7 Removing the 10K resistor TO MAKE THE PHOTO EYE WORK WITH N.O. Take the following steps to remove the 10K resistor. This only removes the 10K resistor, the photo eye is still UL certified. STEP 1: STEP 2: Remove 4 screws as shown. Cut the R42 resistor on the board as shown.
- Page 8 This warranty does not extend to (a) the photo eye case, which can be damaged by conditions outside the control of Transmitter Solutions, or (b) battery life of the photo eye. This warranty is further limited by the following disclaimer of warranty...