Advertisement
Charging Steps
Make sure the charging port is dry and open the charging port cover.
· Step 1: First plug the AC end of the charger into a wall outlet (100-240V, 50-60 Hz), confirm that the
indicator light of the charger is always-on green light. And then plug the DC connector of the charger
into the charging port of the hoverboard.
· Step 2: When the red indicator on the charger lights, it means the charging is normal. If not, please
check whether the circuit connection is good.
· Step 3: When the red indicator light on the charger turns to green light, it means it is fully charged.
Please stop charging as long time charging will affect the service life of the battery.
Note:
· Pay attention to use the local standard wall plugs.
· Please charge and store the battery according to regulations, otherwise it will damage the battery and
affect the battery life.
· The battery charging time is about 4-5 hours. Charging the battery too long will affect the battery life.
· Please keep the charging environment clean and dry.
· Do not charge when there is water in the charging port.
1 4
High or low temperature
To charge the battery with the most e ciency, its battery temperature before and during charging must
be within the marked temperature range. If it is extremely cold or hot, the charging time will be
prolonged or it will not be fully charged.
Battery parameters
Item
Battery type
Charging time
voltage
Initial capacity
Working temperature
Charging temperature
Storage time
Stored relative humidity
Precautions when transporting batteries
WARNING!
Lithium batteries are dangerous, get local law permission when trans-
porting them.
NOTE :
If you need to transport the lithium-ion battery of the two-wheeled hover-
board by air, or other transportation methods, please contact the compa-
ny's designated agent.
Parameters
Lithium battery
4 or 5 hours
36V
4Ah
-15℃~+50 ℃
0~40℃
12 months (-20℃~+25℃)
5%-95%
1 5
Advertisement
