Customer assumes and shall bear the risk of all loss or damage to the Products from every cause whatsoever, whether or not insured, and title to such Products shall pass to Customer upon PACE Technologies delivery of the Products to the common carrier of Pace Technologies choice, or the carrier specified in writing by Customer, for shipment to Customer.
Page 4
All Returns are subject to a restocking charge equal to 15% (fifteen percent) of the Invoice, unless the Goods are proved to be non-conformed by PACE Technologies Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
Page 6
The OMEGA SRT-15/150 dual Superficial / Rockwell hardness testing for evaluating metallographic specimen hardness. The OMEGA SRT-15/150 dual Superficial / Rockwell hardness tester with a load range of 15 kg 45 kg for Superficial Rockwell testing and 60 kg to 150 kg for Rockwell testing.
Page 9
Install unit carefully! Improper installation voids warranty. The OMEGA SRT-15/150 should be placed on a flat stable vibration free surface. If tall or high samples are to be tested so that the up / down lead screw is lowered significantly, a hole will need to be made in the table (see drawing for specifications - mm) 2.3.1 Install leveling feet...
Careful attention to this instruction manual and the recommended safety guidelines is essential for the safe operation of the OMEGA SRT-15/150 . Proper operator training is required for operation of the OMEGA SRT-15/150 . Any unauthorized mechanical and electrical change, as well as improper operation, voids all warranty claims.
Web: http://www.metallographic.com 5.0 Maintenance 5.1 Introduction The OMEGA SRT-15/150 requires very minimal maintenance. However, to increase the life of the Dual Rockwell/ Superficial hardness tester, it is suggested that the unit be covered when not in use. 5.2 Cleaning outside cabinet The cabinet should be cleaned occasionally with a moistened cloth.
Need help?
Do you have a question about the OMEGA SRT-15/150 and is the answer not in the manual?
Questions and answers