The Control Panel; Changing A Program - Sharp QW-NS12I49EX-EN User Manual

7. THE CONTROL PANEL

i
2
1
1. On/Off button
2. Program Selection Button
i. Program Leds
3. Half Load Button
ii. Half Load Led
4. Delay Button
iii. Delay Leds
iv. Salt Indicator
v. Rinse Aid Indicator
vi. End of Program Indicator
1. On/Off Button
Switch the machine on by pressing On/Off
button. When machine is on, the End Of
Program Indicator (vi) will illuminate.
2. Program Selection Button
Select a suitable program for your
dishes by pressing Program
Selection button. The Program Led (i)
corresponding to the selected program will
illuminate and the End Of Program Indicator
(vi) will switch off. The program will start
automatically when the door is closed.
3. Half Load Button
Press the Half Load button to reduce the
duration of the selected program, and
therefore decrease your energy and water
consumption. When Half Load option is
selected, Half Load led (ii) will illuminate.
4. Delay Button
Press the Delay button to delay the start
time of a program for 3, 6 or 9 hours.
Pressing once will delay the start time for 3
hours, pressing twice for 6 hours, and three
times for 9 hours. Press the Delay Timer
button to change or cancel the delayed start
time. The Delay led (iii) corresponding to
the remaining delay duration (3h, 6h, 9h)
ii
iv
v
3 4 iii vi
EN - 17
will be on. If you switch off the machine
after activating the delay time, the delayed
time is cancelled.
NOTE: If you decide not to start the
selected program, please see the
"Changing a Program" and "Cancelling a
Program" sections.
NOTE: When there is insufficient
softening salt, the Salt Lack Warning
Indicator (iv) will illuminate to indicate the
salt chamber needs filling.
NOTE: When there is insufficient rinse
aid, the Rinse Aid Lack Warning Indicator
(v) will illuminate to indicate the rinse aid
chamber needs illing.

7.1. Changing a Program

Follow the steps below to change a program
while in operation.
Open the door and select a new
program using the Program
After closing the door, the new
program will resume the course of
NOTE: Open the door slightly at first to
stop a program before it is complete in
order to avoid water spillage.
Selection button.
the old program.