Daily Use - Electrolux EHL6740FOK User Manual

DAILY USE

ACTIVATION AND
DEACTIVATION
Touch
tivate the appliance.
The control panel comes on after you acti-
vate the appliance and goes off after you
deactivate the appliance.
When the appliance is deactivated you can
see only
AUTOMATIC SWITCH OFF
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated (
• You do not set the heat setting after you
activate the appliance.
• You spill something or put something on
the control panel for more than 10 sec-
onds, (a pan, a cloth, etc.). An acoustic
signal sounds some time and the appli-
ance deactivates. Remove the object or
clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before you
use the appliance again, wait for the
cooking zone to cool down.
• You use incorrect cookware. The symbol
comes on and the cooking zone de-
activates automatically after 2 minutes.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deacti-
vates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
,
•
-
•
-
•
THE HEAT SETTING
Touch the control bar at the heat setting.
Change clockwise or counterclockwise, if it
is necessary. Do not release before you
have a correct heat setting. The display
shows the heat setting.
for 1 second to activate or deac-
sensor field.
- — 6 hours
— 5 hours
— 4 hours
- — 1.5 hours
BRIDGE FUNCTION
The Bridge function connects two cooking
).
zones and they operate as one.
First set the heat setting for one of the
cooking zones.
To activate the Bridge function for left/right
cooking zones touch
change the heat setting touch one of the
left/right control sensors.
To deactivate the Bridge function touch
/ . The cooking zones operate inde-
pendently.
When you use only one cooking zone of
the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.
AUTOMATIC HEAT UP
You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see the
diagram), and then decreases to the nec-
essary heat setting.
To start the Automatic Heat Up function for
a cooking zone:
1.
Touch
play).
2.
Immediately touch the necessary heat
setting. After 5 seconds
in the display.
To stop the function change the heat set-
ting.
ENGLISH
/ . To set or
( comes on in the dis-
comes on
7