Table of Contents
Advertisement
Installation and connection
en
Depending on how you connect the
5.
hose (A, B or C), secure the drain
hose with the remaining accessories
on the other side.
Caution!
Blocked water can be drawn back
into the dryer and may cause
material damage.
Check that the water can flow away
quickly out of the wash basin. The
drain must not be sealed or blocked.
Caution!
Material damage due to leaks or
draining water.
Secure the drain hose so that it
cannot slip out. Do not kink the drain
hose. Observe the height difference
between the installation surface and
the drain of max. 100 cm, and 80
cm for a drain in a siphon.
Pull out the condensate container
6.
fully.
30
Turn the condensate container by
7.
180° onto its underside and release
the stopper which is fitted there. Turn
the container back by 180° and
press the stopper into the opening
on the upper side of the condensate
container.
Pull the filter out of the notch and
8.
place it into the recess on the
condensate container.
Push in the condensate container
9.
until it locks into place.
The condensation is now discharged via
the drain hose into the waste-water
system or into a wash basin
If you want to change the
Note:
condensation drain back to the
condensate container, carry out these
steps in reverse order.
Advertisement
Table of Contents
