Honda CLARITY 2021 Owner's Manual page 37

VSA® On and Off
● The Vehicle Stability Assist
TM
system helps stabilize the vehicle during
cornering and helps maintain traction
while accelerating on loose or slippery
road surfaces.
● VSA® comes on automatically every time
you turn on the power system.
● To partially disable or fully restore VSA®
function, press and hold the button until
you hear a beep.
CMBS TM On and Off
(P 438)
● When a possible frontal collision is likely
unavoidable, the CMBS TM can help you to
reduce the vehicle speed and the severity
of the collision.
● To turn the CMBS
TM on or off, press and
hold the button until you hear a beep.
Tire Pressure Monitoring
System (TPMS)
(P 418)
● Detects a change in tire conditions and
overall dimensions due to decrease in tire
pressures.
● The TPMS is turned on automatically
every time you turn on the power system.
● A calibration procedure must be
performed when certain conditions arise.
Refueling
(P 416)
(VSA®)
Fuel requirement: Compressed hydrogen gas
Hydrogen supply pressure: 70 MPa (10,153 psig) (at 59°F [15°C])
Hydrogen filling amount
Hydrogen tanks capacity: 37.3 US gal (141.3 L) (at 70 MPa [10,153 psig])
*1: A measured value when refueled at a hydrogen station with 70 MPa (10,153
psig) of supply pressure compliant with the SAE (J2601) fueling protocol.
Hydrogen Filling Station: To completely fill the hydrogen tank, you need to use a
hydrogen filling station that has an H70 dispenser, which is capable of supplying
pressures of up to 10,153 psig (70 MPa).
Refueling the vehicle is only possible if the pressure inside the hydrogen tank of
the vehicle does not exceed the supply pressure of the filling station.
If you use an H35 dispenser, you will be able to fill only half of the tank.
a
Set the power mode
to OFF.
b
Press the hydrogen
fuel lid release
button on the
driver's door to open
the fuel lid.
c
Remove the dust cap
inside the hydrogen
fuel lid.
d
Start refueling.
(P 447)
*1 : Approximately 11 lbs (5 kg) (at 70 MPa)
35