Table of Contents
Advertisement
26
www.aeg.com
Water hardness levels
Levels
Soft
4)
Medium
Hard
1) French degrees
2) German degrees
3) English degrees
4) Factory setting, able to satisfy most of the use conditions.
10.4 AutoDose configuration
mode
Enter the AutoDose
configuration mode before
proceeding with any
programme setting. The
configuration mode may
cancel temporary settings .
1. Press the On/Off button for a few
seconds to activate the appliance.
2. Wait about 10 seconds for appliance
internal check.
3. To enter in configuration mode, hold
pressed the Temperature and the
Spin buttons simultaneously for a few
seconds until
detergent tank
indicators appear in the display.
After 10 seconds without interacting
with control panel the appliance exits
the configuration mode.
4. Touch related tank buttons to toggle
function off and on. The display
shows OFF when a tank is disabled
Water hardness range
1)
°f
°d
<15
<8
15 - 25
8 - 14
>25
>14
and the blinking
and softener tank
2)
3)
°e
<10
0 - 17
>17
or shows tank indicator when it is
enabled.
5. To set basic dosage touch related
tank buttons until default dosage
laundry product and two arrows on
bottom of display appear. Touch the
Temperature button repeatedly to
decrease the dosage and the Spin
button to increase it: minimum step is
1 ml (each single step) or 10 ml
(when button is hold pressed).
6. After about 10 seconds the display
returns to the programme information
screen or hold pressed the
Temperature and the Spin buttons
again to exit immediately.
mmol/l
ppm
<1.4
<140
1.5 - 2.5
150 - 250
>2.5
>250
Advertisement
Table of Contents
