Table of contents Foreword ���������������������������������������������������������������������������������������������������������� 1 Read this manual carefully! ������������������������������������������������������������������������������������������ 1 Safety Instructions ������������������������������������������������������������������������������������������ 2 Symbols used �������������������������������������������������������������������������������������������������� 4 Product description ����������������������������������������������������������������������������������������� 5 Use of Atle® 180 ���������������������������������������������������������������������������������������������� 6 General horizontal transfer of patient ������������������������������������������������������������������������ 6 Transfer at bowl-shaped CT-scanner ������������������������������������������������������������������������� 8 Attachment solution with hooks in a stretcher or trauma mattress ��������������������������...
Njord Medtech recommends and warns that to avoid injuries attributed to the use of Definitions used in this manual inadequate parts, only parts designated by Njord Medtech should be used on products WARNING: and other appliances supplied by Njord Medtech.
Safety Instructions Keep the manual together with the product WARNING: Using Atle® 180 beyond its so that it can be used as reference or life span may result in an incident causing provide access to online documentation serious injuries at njordmedtech.com. Store the Quick Reference Guide that comes with the product Important Safety Instructions well visible to all staff.
Page 6
Safety Instructions In case of deviation WARNING: No modification of this equipment is allowed In need of immediate shutdown during transfer, the emergency stop switch on the WARNING: Do not put fingers, hands or product is to be used. other body parts where space is limited (see Fig 1).
Symbols used Atle® 180 unit has a traceability product label with the symbols below, the other symbols can be found on Atle® 180 or in the Instructions for Use. CE marking indicating conformity with European Error indication Community harmonies legislation The maximum load the device is tared for safe usage / Maximum Battery indication...
Product description Fig 2 1) Attachment solution (replaceable) 7) Wire guide 2) Transfer bar 8) Emergency stop 3) Wire (replaceable) 9) Reset button for emergency stop 4) Wheel brake 10) Charger output 5) Hand Control with battery indicator 11) Hand Control output 6) Bobbin (replaceable) 12) Battery charger and power cord To disconnect the device, pull out the charger from the appliance and/or pull out the plug...
Use of Atle® 180 General horizontal transfer of patient The transfer technique described below can be used for patients lying in bed to transfer them horizontally between beds, from stretcher to bed and bed to examination table and vice versa. Before transfer 3) Place the bed parallel to and approximately 0.5 meters from the other unit.
Page 10
Use of Atle® 180 During the transfer the transfer starts. Press the pull button again and perform the transfer. 5) Ensure that the bed and examination table Make sure that the patient is following the are placed at the same height right next to transfer, especially the feet, shoulders and each other.
Use of Atle® 180 Attachment solution with hooks in a stretcher or trauma mattress For all types of mattresses with handles along the side, the hook is attached to the loop of the wires and then connected directly to the handles on the mattress.
Use of Atle® 180 Attachment Solution Before transfer 1) Prior to patient transfer, check that the sheet is stretched under the patient and lay the transfer bar on the sheet close to the patient and with the ends of the transfer bar at the level of the shoulders and hips.
Use of Atle® 180 Charging and Hand Control try to run a function when the batteries are charging, the alert LED only lights up while you are trying to activate a function (i.e. when Charging Batteries you press a button). The battery pack is the type of rechargeable Battery indicator Lead.
Use of Atle® 180 Buttons NOTE: Only the supplied charger and hand control should be used Pulling button WARNING: Periodic checking or replacement of the charger is neccessary Fig 19 Brakes and Emergency Stop The button with double arrows is used to pull the patient towards Atle®...
Page 15
Use of Atle® 180 First-time users should practice the emergency stop manoeuvre before operating. Fig 24 Emergency stop Reset button Hand Control Charger Output Output After Use When the expiration date of the device is reached, the product must be recycled according to set standards for each country and hospital.
Cleaning and service Cleaning of Atle® 180 Surfaces that the caregiver touches must be cleaned manually after each transfer. Clean the surfaces of Atle® 180 regularly with single-use cloths with hot water or pH neutral detergent. For disinfection use the regular surface disinfectant.
Page 17
Cleaning and service 6) Close the cover Fig 29 Fig 32 4) Take a new bobbin and attach it by pushing it onto the pin. Finish by tightening the screw. Fig 33 NOTE: Incorrectly placed bobbins may fall Fig 30 off the pin and the patient transfer cannot be performed 5) Put the wire back into the wire guide.
Cleaning and service Maintenance Replacement of components must be done by medically trained staff or by the manufacturer service staff. More severe contamination may require the external parts to be unscrewed, and the internal components to be cleaned by medical personnel. Preventive and check-up service is recommended once per year.
Page 19
LEDs on the hand control will wander. If the battery is not taking charge or the battery has a short operating time, replace the battery* * The battery (power pack RPP10) can be ordered from Njord Medtech or designated distributor...
Cleaning and service Troubleshooting Type of error Action Possible cause Hand control does not respond - The emergency stop button is - Deactivate the emergency stop activated by clicking on the “reset” button - The plug to the hand control is on the control panel unplugged - Summon technical trained...
Page 21
Cleaning and service Troubleshooting Type of error Action Possible cause Error indication on the hand - Problem with power supply or - Reset the device with the control glows red (indicates motor. “reset” button on the control charging, charging level and - Charge the battery (connect error indication) the charger to the device and...
Atle® Labels Reset Reset Reset button for the emergency stop STOP STOP Emergency stop ATLE® 180 Product name Charger output Pinch / Squeeze (inside the lid on Hand Hand both sides) Control Control Hand control output Product label (on the backside) Serial number Manufacturer Data Manufacturer Date...
Technical Specification Product data Life expectancy is 40,000 transfers with Atle® 180 Product information Atle® 180 The total weight of the 50 kg product Maximum patient weight to 180 kg transfer Time required for transfer 15 seconds Maximum temperature 43°C Electrical Battery type Lead, ventilated housing...
Page 24
Technical specification Safe Disposal and END of LIFE All batteries in the product must be recycled separately. Battery Batteries are to be disposed in accordance with national or local regulations. Sealed lead-acid, rechargeable, recyclable. Package Wood and corrugated cardboard, recyclable. Systems having electrical &...
Atle® 180 WARNING: Use of accessories, cables and spare parts other than those specified or provided by Njord Medtech could result in increased electromagnetic emissions or decreased electromagnetic immunity of Atle® 180 and result in improper operation WARNING: To operate properly, Atle®...
Electromagnetic Compatibility Electromagnetic Emissions Guidance and Manufacturer´s Declaration - Electromagnetic Emissions - For all Equipment and Systems Atle® 180 is intended for use in electromagnetic environment specified below. The customer or the user of Atle® 180 should assure that it is used in such an environment. Electromagnetic environment IEC 60601 Compliance level...
Electromagnetic Compatibility Electromagnetic Immunity Guidance and Manufacturer´s Declaration - Electromagnetic Immunity - For all Equipment and Systems Atle® 180 is intended for use in electromagnetic environment specified below. The customer or the user of Atle® 180 should assure that it is used in such an environment. Electromagnetic environment IEC 60601 Immunity test...
Page 29
Electromagnetic Compatibility Electromagnetic Immunity Guidance and Manufacturer´s Declaration - Electromagnetic Immunity - For all Equipment and Systems Atle® 180 is intended for use in electromagnetic environment specified below. The customer or the user of Atle® 180 should assure that it is used in such an environment. Electromagnetic IEC 60601 Immunity test...
Page 30
Njord Medtech® is set on a mission to solve unmet needs in radiology and patient handling for sustainable healthcare. The company has been incubated within the Sahlgrenska University Hospital since 2017 and incorporated in 2019. Manufacturer Njord International AB Medicinaregatan 8 SE-413 90 Göteborg...
Need help?
Do you have a question about the Atle 180 and is the answer not in the manual?
Questions and answers