Telefunken TKP2198USM Service Manual page 25

2. Enter P-Mode, press key "5" to select page "5". Set the corresponding item to require
value. See below table 3.7.2 for detailed description.
Table 3.7.2: Producing parameter setup and option page "5"
OSD menu Default Value
Track. Mode
VX Normal
VX Compr.
WBF
WBR
GET OFFSET
ColdRC
ColdGC
ColdRD
ColdGD
WarmRC
WarmGC
WarmRD
WarmGD
Description for AUTO OFFSET and GET OFFSET:
The "GET OFFSET" can use to make the EEPROM copy by PE engineer. When the
PAL and NTSC geometry adjustment had finished, trigger the "GET OFFSET" from "0" to
"1" to store the geometry offset datum between PAL and NTSC in EEPROM.
On producing, these geometry offset datum can use to easy the NTSC geometry
adjustment. When finished the PAL geometry adjustment, trigger the "AUTO OFFSET"
from "0" to "1", then the geometry adjustment of NTSC signal will finish automated. If now
the geometry of NTSC signal is look good, it not needed to adjust the geometry of NTSC
signal any more.
3. Enter P-Mode, press key "6" to select page "6". Set the corresponding item to require
value. See below table 3.7.3 for detailed description.
Table 3.7.3: Producing parameter setup and option page "6"
OSD menu Default Value
AGCT
AGC
OIF
Chassis Name
Issued on
Updated on
Description
1 EHT tracking mode
25 4:3 mode vertical zoom
0 16:9 mode vertical zoom
5 Wide blanking start
8 Wide blanking end
0 Get offset
61 Cold color temperature R
and G cut-off offset
56
61 Cold color temperature R
66 and G drive offset
72 Warm temperature R and G
cut-off offset
71
65 Warm color temperature R
and G drive offset
64
Description
32 AGC take over point
0 AGC take over point indicate
32 IF demodulator offset
NX56-AP&NX56B-AP
2008-01-18
2009-04-24
0=EHT tracking only on vertical
1=EHT tracking on vertical and EW
Don't adjust, use default
Don't adjust, use default
Don't adjust, use default
Don't adjust, use default
See below description for detailed
Recommended value= "61"
Recommended value= "56"
Recommended value= "61"
Recommended value= "66"
Recommended value= "72"
Recommended value= "71"
Recommended value= "65"
Recommended value= "64"
See section "3.2 RF AGC alignment"
for detailed.
Serial No.
Page 14 of 17
Page
4.0
Version
Remark
Remark
Don't adjust, use default