Tekno K1 Quick Start Manual

Automation Systems
Specifications
Power: 12V DC
Standby Current: ≤35 mA
Operating Current: ≤100 mA
Maximum Users: 10,000 Users in Standalone Mode
Operating Temperature: -40°C to +60°C
Operating Methods: PIN CODE, RFID, MOBILE APP
Wi-Fi: 2.4GHZ ONLY, Up To 10 Metre Distance (1 Wall)
Default ADMINISTRATOR Code
9 9 9 9 9 9
Programming Access Code ONLY
About
The Tekno K1 Wired keypad allows for access by pin number, RFID car/tag or by operation on the APP. It can operate as a stand-alone
device or work with a Wiegand controller. Supporting NO and NC relay function it can momentarily pulse or latch up to 99 seconds. Two
factor authentication is also available by CARD/TAG then PIN, or alternatively used as standard card/pin unlocking.
1. Install the backing plate to the
post or wall using the appropriate
fasteners.
LED and Buzzer
Ready for Admin PI code
1
Second
Quick Reference to add a Common Pin Code
If only requiring a simple setup of only one common PIN code
the step outlined below can be used to bypass all advanced
steps and quickly add the PIN. Note that 1234 CANNOT be
used as a PIN number.
Australia
2. After completing wiring install the keypad
to the backing plate clipping into the top clips
from a 45° angle and bring down slowly til
seated.
PIN Error
Bi Bi Bi
1
1
Second
Second
Standalone Wired Keypad with RFID and App Control
Correct Pin Code
Relay
Time
9 9 9 9 9 9
*
TEKNO
+12V DC (RED)
GND (BLACK)
OPEN (Yellow)
D0 (Green)
D1 (White)
N/O (Blue)
COM (Purple)
N/C (Orange)
EM Card and Tag Reader
3. Install the small retaining screw.
In a setting Menu
# 0 9 A A A
4-6 Digit PIN
K1
Power
Exit Button
Wiegand
Relay
A A A #
*
Page 1