RemotePoint Presenter Global VP4350, VP4360 Manual

First Use

1. Install batteries in the battery compartment.
   
2. With the computer turned on, plug the receiver into a free USB port. (If the computer displays a " Found New Hardware" dialog box, click Next until the driver is installed.)
   
3. Initialize the Global Presenter by pressing the Blank button within 10 minutes of connecting the receiver.
   

Changing The Blank Key Code

In certain languages, a different key code may be needed to blank the screen during a presentation. Three key codes are provided for the various presentation programs.
To change between the codes:

• Insert the receiver into a USB port.
• Use a paper clip to press and release the recessed button on the receiver.
• The LED on the receiver will turn orange.
  
• Start a slide show and test the Blank screen feature.

Setting up the Device

Your presentation remote comes set up from the factory. In most situations, no adjustments are needed; however, if you have many remotes or another device which is causing interference, complete these steps to avoid interference.

Training The Receiver

1. To train the receiver to accept the digital code from the remote, remove the USB receiver from the USB port and reconnect it after a few seconds.
2. Press and hold the Next button (the right arrow) for 10 seconds until the red light on the remote turns back on. The LED on the receiver should turn from flashing green to solid green then back to flashing green.

Changing Channels

1. Remove the battery from the remote.
2. Replace the battery and hold down the Previous button (the left arrow) for 10 seconds.
3. The LED on the remote will blink the number of the current channel. Each time you press the Previous button, it increases the channel by one.
4. Once you are on channel 4, increasing the channel will move it back to channel 1.
5. The LED will blink rapidly the number of the current channel.
6. Press the Next button (the right arrow) to confirm the channel.
7. Train the receiver again using the steps listed in " Training the Receiver."

Device Controls

Support

SMK-Link Electronics Corporation
3601-B Calle Tecate
Camarillo, CA 93012

TEL: (888) 696-3500
FAX: (805) 987-6665

Register online at www.smklink.com/register.

Documents / Resources

References

• Product Registration

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download RemotePoint Presenter Global VP4350, VP4360 Manual