Advertisement
Press and hold the "Control Button" (1) for 1 second. Your headphones will turn on and automatically enter pairing mode.
Open Bluetooth settings on your device and select "Urbanista Los Angeles". The "Battery Status Indicator" (2) will flash to indicate pairing mode and stop flashing when successfully paired.
The headphones will automatically reconnect to the same device you have paired them to when next turned on.
Disconnect the headphones from the device to enter pairing mode again or to connect to another device. The headphones can store up to six paired devices.
Urbanista Los Angeles has a built-in PowerfoyleTM solar cell that continuously charges your headphones whenever exposed to any light providing you with virtually infinite playtime. The self-charging occurs in direct and indirect solar light as well as indoor light, but the stronger the light, the more effective. When you are not using your headphones, place them somewhere where the PowerfoyleTM area is exposed to light, for example, a windowsill.
In addition, Los Angeles has a battery saving feature that will automatically power off the headphones if Bluetooth is disconnected for 5 minutes or if the headphones are not worn for 30 minutes.
Should the battery for some reason run low, a "Battery low" voice prompt will notify you when there are 30 minutes of playtime remaining, after which the headphones will automatically turn off.
Use the included USB Type-C cable connected to a power source to charge the headphones. The "Battery Status Indicator" (2) will lit red continuously when charging and turn white when fully charged.
POWER ON – Press and hold the "Control button" (1) for 1 second.
POWER OFF - Press and hold the "Control button" (1) for 5 seconds.
PLAY – Press the "Control button" (1) once.
PAUSE – Press the "Control button" (1) once.
ANSWER A CALL – Press the "Control button" (1) once.
END A CALL – Press the "Control button" (1) once.
REJECT A CALL – Press and hold the "Control button" (1) for 2 seconds.
VOLUME UP – Press the "+" button (3) once.
VOLUME DOWN – Press the "–" button (3) once.
NEXT TRACK – Press and hold the "+" button (3) for 2 seconds.
PREVIOUS TRACK – Press and hold the "-" button (3) for 2 seconds.
ACTIVE NOISE CANCELLING – Press the "Feature button" (4) one time.
AMBIENT SOUND MODE – Press the "Feature button" (4) a second time.
DEFAULT MODE – Press the "Feature button" (4) a third time to return to default mode.
VOICE ASSISTANT – Press the "Feature button" (4) for 2 seconds.
To reset your Los Angeles headphones to the default settings, please follow the below steps.
If you have any additional questions, please visit our online help center where you will find our FAQs and an online version of this manual: https://support.urbanista.com/
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Los Angeles that isn't answered in the manual? Leave your question here.