Antlion Audio Kimura - In-Ear Headset Manual

CONTENTS

1. Left earphone
2. Right earphone
3. 2 x Foam and 6 x Silicone eartips
4. Kimura Microphone Cable
5. Shirt clip
6. Antlion Y Adapter
7. Carrying case

HOW TO INSERT EARPHONES AND ADJUST HEADSET

1. Identify Right/Left
   
2. Place earloop over/behind ear
   
3. Insert earphones and rotate to seat into ear canal
   
4. Adjust for good seal
   
5. Bend earloop up to secure cable junction underneath earlobe
   
6. Ensure earloop is positioned snugly behind the ear and position mic near corner of mouth
   

HOW TO INSERT FOAM TIPS

1. Roll tip between your fingers to compress
2. Insert into ear and hold
3. Tip will expand to fit ear canal

PRO TIPS

Use the shirt clip to reduce cable noise and tugs.
Keep the mic tip at or behind the corner of your mouth to reduce plosive and high-volume mic overdrive.
If you need to extend the cable, extend both mic/audio separately; joining them in a single TRRS extension can cause cross-talk.

TROUBLESHOOTING

Earphones are uncomfortable: try different eartips for each ear and ensure earphones are on the correct sides.
Microphone boom bounces with movement: bend earloop so that it fits snug underneath earlobe, use shirt clip to reduce wire pulling.
Sound does not work: make sure the mic and headphone lines are connected to the correct jack. Red: microphone, green: headphones. If your system has only one jack, use the included TRRS adapter.
Sound lacks bass: try different ear tips for better seal in ear canal.
Others hear themselves/echo in my mic signal: when possible, avoid using single-port headset jacks and always extend the headphone and mic cables separately.