Tristar KB-7424 - Cooling Box Manual

Table of Contents

PARTS DESCRIPTION

Parts Overview

Take the appliance and accessories out the box. Remove the stickers, protective foil or plastic from the device.
Before using your appliance for the first time, wipe off all removable parts with a damp cloth. Never use abrasive products.
Your coolbox is able to keep your pre-cooled food and drinks refreshingly cool with very little power requirement.
Thanks to the insulation, the food and drinks inside the box will remain fresh for a long time, even without electric power for cooling.
Ensure that the box is placed in a position where the air from the external fan is free to circulate.
Do not place the box in direct sunlight.
Install the appliance on a firm, horizontal surface. Avoid installing the appliance in direct sunlight or near any source of heat.
In all cases, the appliance shall be protected from rain and splashing.
To guarantee a good level of air circulation, do not obstruct the ventilation grids.
Even little children should not sit or stand on the appliance: the appliance will be damaged as the balance of the fan will be disturbed.

Plug the connector supplied with the refrigerator into the cigar lighter socket of the vehicle and ensure that the connecting cable is fully extended as failure to do so, can lead to cable burning!

Liquids to be stored in the refrigerator shall always be placed in a closed vessel.
The air circulation inside the appliance must not be obstructed.
Never place hot food or drink in the appliance.
Never keep flammable liquids and/or gases inside the refrigerator. Danger of explosion.

The inside of the device should be cleaned at least monthly for the hygiene. Always remove the plug from the socket when the device is cleaned.
For cleaning you can easily remove the lid from the box. Open the lid for 80% and lift up the lid, now you can remove the lid. For installing the lid make sure the notches on the lid will match the slots in the box and but it back in position.
Clean the inside and outside of the box with a water with a mild detergent.
Clean the lid with a damp cloth. Never use harsh and abrasive cleaners, steel wool or a scouring pad as this will damage the device. Make sure that no moisture enters the cooling slots and do not immerse in water or other liquid.