DeLOCK 62619, 62620 - Network Isolator Manual

Description

The Delock RJ45 Isolator protects the network connection of a device against overvoltage. The compact device supports Ethernet with 10/100/1000 Mb/s.

Specification

• Connector:
  1 x RJ45 female (device)
  1 x RJ45 female (extern)
  1 x screw terminal for equipotential bonding
• Data transfer rate up to 10/100/1000 Mb/s
• 6 kV Isolation (10 / 700 us)
• Housing material: plastic
• Dimensions (LxWxH): ca. 70 x 25 x 25 mm

Only 62620:

• Supports PoE devices

System requirements

• Device with a free RJ45 port
• Network cable (max. 50 cm)

Package content

• Isolator
• User manual

Safety instructions

• Protect the product against moisture
• Protect the product against direct sunlight

Installation

1. Switch off all power connections to the connected Ethernet devices.
2. Connect the RJ45 cable from external side to the RJ45 port marked "Ext".
3. Connect the RJ45 cable from the internal, to be protected device, to the RJ-45 port marked "PC". The internal cable should be as short as possible.
4. Connect the ground wire to the screw terminal.
   
   Make sure the isolator is securely grounded. This allows excess current to flow to ground.
5. Switch on power connections to the Ethernet devices.

Support Delock

If you have further questions, please contact our customer support support@delock.de
You can find current product information on our homepage: www.delock.com

Final clause

Information and data contained in this manual are subject to change without notice in advance. Errors and misprints excepted.

Copyright

No part of this user manual may be reproduced, or transmitted for any purpose, regardless in which way or by which means, electronically or mechanically, without explicit written approval of Delock.

EU Import: Tragant Handels- und Beteiligungs GmbH
Beeskowdamm 13/15, 14167 Berlin, Germany