EASYmaxx - Spa 11099 Shower Head with LED Colour Changing Instructions

INTENDED USE

• This product is intended to be used as a shower head on shower hoses with a 1/2" internal thread.
• The product is designed for personal use only and is not intended for commercial applications.
• Use the product only for the intended purpose and as described in the operating instructions. Any other use is deemed to be improper.
• The warranty does not cover faults caused by incorrect installation, handling, damage, calcification or attempted repairs. The same applies to normal wear and tear.

ITEMS SUPPLIED

1 x shower head with mineral beads
1 x sealing ring
1 x operating instructions
Check the items supplied for completeness and the components for transport damage. If you find any damage, do not use the product but contact our customer service department.
Remove any possible films, stickers or transport protection from the product.

AT A GLANCE

1. Head
2. Mineral beads
3. External thread 1/2"
4. Plate with nozzles
5. Display showing temperature
6. LEDs (under the plate)

INSTALLATION AND USE

Please Note!

• Do not apply any force during installation and cleaning or when replacing the mineral beads! The shower head could be damaged.
• Tighten the screw connections hand-tight.
• Do not use any caustic or abrasive cleaning agents or cleaning pads to clean the product! These may damage the surfaces.

1. Screw the thread of the shower head (3) as far as it will go into the thread of the shower hose (Picture B). Make sure that the sealing ring fits correctly when you do this.
   
2. If you have not already fitted it, connect the shower hose to the water pipe.
3. Open the tap.
   The current water temperature is shown on the display.
   The LEDs in the shower head light up to indicate the temperature:

   green	≤ 31°C
   blue	32°C – 43°C
   red	44°C – 50°C

The generator in the shower head supplies power to the LEDs and the display when the water pressure reaches at least 2 bar.

CLEANING THE SHOWER HEAD

• Remove limescale deposits with a standard descaling agent. Follow the instructions from the manufacturer of the descaling agent when you do this.
• Clean the shower head with standard cleaning agent and a damp cloth or sponge.
• Clean the shower head and descale the nozzles at least every three weeks or when the nozzles are clogged.

TECHNICAL DATA

SAFETY NOTICES

• Keep the packaging material and mineral beads away from young children and animals. There is a danger of suffocation!
• Before you use the product, make sure that it is undamaged. If the product is not leak proof, there is a danger of electric shock!
• Do not disassemble the shower head. The LEDs cannot be replaced.
• Before you use the product, make sure that it has been connected correctly.
• The product is not a toy! Supervise children to ensure that they do not play with the product. There is a danger of injury from incorrect use!