Advertisement
5. OPERATION
5.1.
Prior to use of the required
attachment, disassemble and
grease as shown in fig.1.
Reassemble the attachment.
5.2.
Screw the attachment into the
shaft, as shown in fig.2. Tighten
the attachment using a wrench.
Note: DO NOT over tighten.
5.3.
Ensure the attachment jaws
are completely closed and insert
the attachment into the inner
diameter of the bearing, fig.3.
5.4.
Turn the handle clockwise to
open the attachment jaws to
grip the bearing. See fig.4.
5.5.
Hold the bearing puller as shown
in fig.5, slide the hammer to the
bearing end of the shaft and
then forcefully pull the hammer
to the other end of the shaft.
5.6.
Ensure the bearing is being
pulled out evenly, if not, remove
the puller attachment and, using
a soft faced mallet, tap the
bearing until it is seated evenly.
5.7.
Repeat paragraphs 5.5 and 5.6
until the bearing has been
removed.
5.8.
Turn the handle anticlockwise to
close the jaws in order to
release the bearing from the
attachment head. See fig.5.
6. MAINTENANCE
6.1.
After use, account for all components, clean with a lightly oiled cloth and return them to the carry case.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, dispose of the product according to local
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
fig.1
Tighten
fig.2
Bearing
Attachment Head
fig.3
Attachment Head
fig.4
Attachment Head
fig.5
Hammer
Environmental Protection
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Loosen
Grease
Attachment Head
Open jaws
Hammer
Close Jaws
regulations.
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
AK714.V3
Issue: 1 - 26/08/15
Advertisement
