Measuring Continuity - Snap-On EEDM596F Manual

Measuring Ohms (Resistance)
Range: 0.00 – 40.00 Meg Ohms
WARNING!
Do not attempt to make resistance
measurements with circuit energized. For
best results, remove the resistor completely
from the circuit before attempting to
measure it.
NOTE:
To make accurate low ohm measurements,
short the ends of the test leads together and press the
REL push button, This value will automatically be
deducted from your reading.
Rotary switch position
Test lead connection
COM – Black Test Lead
VΩHz – Red Test Lead
Optional functions
Activates manual ranging. Hold in for 2 seconds
to return to auto range.
Activates the Min/Max/Ave Record mode.
Hold in for 2 seconds to deactivate.
Toggles between +/- trigger in IP or IG function.
Activates relative mode.
Hold in for 2 seconds to deactivate.
Activates Data Hold on non-automotive
functions. Press again to deactivate.
Hold down for 2 seconds to activate 1mS Peak
Hold on DC volt and DC current functions.
EEDM596F-Z Rev. B
EEDM596F
Advanced Digital Multimeter
With Color LCD and Bluetooth®

Measuring Continuity

Range: Buzzer sounds at <10Ω
Rotary switch position
Selecting the continuity mode
Test lead connection
COM – Black Test Lead
VΩHz – Red Test Lead
Optional functions
8
WARNING!
Do not attempt to make continuity
measurements with circuit energized.
Press this button so the symbol is on the LCD.
Activates manual ranging. Hold in for 2 seconds
to return to auto range.
Activates the Min/Max/Ave Record mode.
Hold in for 2 seconds to deactivate.
Toggles between +/- trigger in IP or IG function.
Activates Data Hold on non-automotive
functions. Press again to deactivate.
Hold down for 2 seconds to activate 1mS Peak
Hold on DC volt and DC current functions.
(05/19)