inforce WML Series Manual page 2

FUNCTIONS
WML WHITE & WMLx WHITE
LIGHT OPERATION
Constant
With LED lever pointing forward in Position (A)
press button once to turn on constant white
light. Pressing button again or moving the lever
from Position (A) to Position (B) will turn the
light off.
In constant mode, momentary is also available.
Press and hold button for more than ½ second
to turn light on. Release pressure off button to
turn light off.
Momentary
With LED lever pointing backward in Position (B)
press and hold button to turn light on. Release
pressure off button to turn light off.
Strobe
With the LED lever pointing forward in Position (A)
quickly press button twice to activate strobe.
Pressing button again or moving lever from
Position (A) to Position (B) will turn light off.
DISABLING STROBE
1. Unscrew head ¼ rotation to lockout position.
2. Press and hold button.
WML WHITE/IR & WMLx WHITE/IR
LIGHT OPERATION
Constant (IR)
With LED lever pointing backward in Position (B)
press button once to turn on constant IR light.
Pressing button again or moving lever from
Position (B) to Position (A) will turn light off.
Momentary (IR)
With LED lever pointing backward in Position (B)
press and hold button to turn light on. Release
pressure off button to turn light off.
A
(white indicator visible)
B
3. While holding button, tighten clockwise back into place.
Once tightened, release button and strobe will be disabled.
Repeat steps 1 - 3 to enable strobe.
OPERATION
MOUNTING WML & WMLx TO RAIL
1. 2.
Turn clamp screw Push clamp toward
counterclockwise body and place onto
until completely rail. Release pressure
loosened. off clamp once on rail.
To dismount light, turn clamp screw counterclockwise until completely loosened.
Push clamp toward body and lift off rail.
LOCKOUT SYSTEMS
There are two lockout methods to prevent
accidental discharge when carrying light.
1. Safety lever protects activation of button.
Lift lever up 90˚to cover button.
2. Unscrew head ¼ rotation.
BATTERY REPLACEMENT
1. Unscrew head to remove it from body.
2. Insert one battery (WML units), or two
batteries (WMLx units) into body. Positive
(+) side first as shown in the figure below.
3. Screw head back into body.
+ -
3.
Finger tighten screw
clockwise until
secured on rail.
DO NOT USE TOOLS.
Head (2)
Lockout Lever (1)
WARNING: Lithium batteries can explode or cause burns if
recharged, shorted, disassembled, exposed to water or high
temperatures of fire. Follow battery manufacturer's guidelines
for safe storage, use and disposal. If light has been submerged,
dry exterior of light prior to replacing batteries. Fresh and salt
water will damage internal electronics and batteries.
Do not use counterfeit or inferior quality batteries, as they
do not meet safety and performance standards and may
cause personal and property damage. Ensure safety and
performance by purchasing established brands, such as:
Duracell, Energizer, or Panasonic.