Ostar T210022 User Instructions

GEEVON
T210022 Atomic Wall Clock User Instructions
Thank you for purchasing T210022 Smart Atomic Luminous Clock.
Please take a moment to read this guide and store it for future reference.
The GEEVON Atomic Clock will receive daily WWVB updates. Daylight Savings Time also automatically updates so there is no need
to re-set the clock manually!
IMPORTANT: If the Atomic Clock does not receive the WWVB signal immediately, wait overnight and it
will be set in the morning.
The clock has a built-in receiver that automatically synchronizes itself with the WWVB radio signal broadcast by the US
Government's National Institute of Standards & Technology(NIST) in Fort Collins, Colorado.

QUICK START GUIDE

1. Choose your time zone [6] and DST [5](Daylight Savings Time) mode on the back of the clock.
2. Place 1 AA battery in the battery compartment. The clock hands will begin to move and the clock will start
searching for the signal.
3. In most areas, a signal can be received at night. If the clock doesn't receive the WWVB Atomic signal
immediately, wait overnight and it will be set in the morning.
Tips:
1. Please place the clock near the window to enhance the signal.
2. The Night Light Clock might run out of energy during a long day in the box, so we advise letting the
wall clock absorb light energy (sunshine or fluorescent lamp) more than 4 hours before installation when
receiving the products. (Please avoid direct sunlight.)