Advertisement
3. Assembly Instructions
•
Carefully unpack and examine the product to ensure that it is complete.
•
Before use, check for any signs of damage e.g. cracked weld, flaking of paint, bent tube. If any
signs occur please contact your supplier to exchange and refrain from using the product.
•
DO NOT ATTEMPT TO USE IF PRODUCT IS DAMAGED.
Push Handles (can be fitted in two ways):
•
The handles can be turned inwards so that they run parallel with the chair back.
•
Or the handles can be used facing out from the back of the chair at 90 degrees to the back.
Footrests:
•
On each side of the front legs of the commode main frame there are two retaining lugs either
side.
•
Take the footrests and align the holes in the inverted "U" section with the lugs.
•
Lower down into place.
•
Rotate the foot rest towards the commode so that they clip into place.
•
They can be rotated up and down as necessary, should they temporarily not be required.
4. Correct Use
•
Please empty the potty at regular intervals and be aware of its maximum
capacity.
Turning seat:
•
The seat simply lifts off the frame and can either be forward or rearward positioned (relative to
cut out)
•
The seat aperture has a plug which can be fitted into the chair when access is not required.
Assistant Handles:
•
They can be adjusted up and down by removing the pin clip and moving the handle to the desired
height.
•
The clip can then be refitted.
Castors:
•
To lock: push down the lever on the castor body (all 4 are
lockable).
•
To unlock: push the lever in the opposite way.
Arms:
•
To swing out of the way: lift the arm approximately 20-30mm and swing out
•
To relocate lift, swing back in and drop the arm slot down onto the locating pin.
Health & Safety
•
Customer/User Please Note: Do not attempt to move the product if the castors are
locked.
71019F/H Potty:
•
This product was developed for greater ease of use. The rear handle was designed intended to
allow easy fitting and removal from the commode and greater control when carrying and emptying.
The upper handle when put in the upright position locks into position for stability. To fold it down,
push the handle vertically downwards to release the locking tabs before folding it backwards
towards the rear handle.
•
The potty can be fitted into the carrier (located underneath the seat) either from the front or the
rear. This is possible when the seat is front or rearward facing.
•
The upper handle will require to be folded down before fitting to the commode.
Ref: X399 Feb 2014
Form No: Cef 0035
User Instruction for the
Bariatric Toileting/
Showering Chair HMC106M
Advertisement
