HIKVISION DS-KABD8003-RS1/S Manual

DS-KABD8003-RS1/S
Module Door Sta�on Protec�ve Shield
UD22613B
E N G L I S H
Diagram References
Installa�on
1
Note: The protec�ve shield is used to installing the main unit of module door sta�on.
Before you begin:
1. Make sure the device in the package is in good condi�on and all the assembly parts are
included.
2. Make sure the place for surface moun�ng is flat.
3. Tools that you need to prepare for installa�on: Drill (ø6), cross screwdriver (PH1*150
mm), and gradienter.
4. Make sure all the related equipment is power-off during the installa�on.
Surface Moun�ng with Protec�ve Shield
1. Paste the installa�on S�cker 1 onto the wall. Make sure the s�cker is placed leveled via
measuring with the gradienter. Drill 4 holes align to the screw holes on the s�cker.
Note:
The suggested size of hole is 6 (diameter) × 25 (depth) mm.
The suggested length of cables le� outside is 100 mm.
2. Remove the s�cker and insert the expansion sleeves into the screw holes. Fix the
moun�ng frame and protec�ve shield onto the wall with 4 expansion bolts.
3. Connect the cables to the corresponding interfaces of the main unit and insert it into the
frame.
4. Use the hexagon wrench in the package to fix the cover onto the frame.
Appearance and Dimension
2
Refers to the figure and table below to see the details.
Parameters
Material Stainless steel
Working
-40° C to +60° C(-40° F to 140° F)
temperature
Working humidity 10% to 95%
Dimension 122 × 116.4 × 58 mm (4.80" × 4.58" × 2.28")
298.9 g
Weight
1
1
Screw Hole
Cable Hole
Expansion
Bolts
2
Moun�ng Protec�ve
Frame Shield
3
4
Hexagonal
Screw
Cover
Main Unit