Table of Contents
Advertisement
Quick Links
Installation Guide
Introduction
Welcome to évoralight: Brighter Together. Our premium LED tape lights are designed and
manufactured to become purpose-centric lighting solutions. Lighting made for humans, by
humans. Continue along to read more about proper installation, safety instructions, and
Warranty information.
UL Listing and Compliance Information
Our products are safe to use and free from
any hazardous substances. To comply with
UL standards and inspections, please keep
in mind that:
A Class 2 power supply is to be used with
each run of lights.
Each installation of LED strip lights in
series should consume no more than
100W maximum.
Tools Needed
Screwdriver
01
www.evoralight.com
Ethos™ Wet Location LED Strip
Ethos
LED Strip
Installation Guide
Scissors
Pliers
Wet Location
™
Español:
Se debe utilizar un transformador de Clase 2 cuando
es necesario ajustarse a las normas de seguridad UL.
La instalación no debe exceder un máximo de 100W
cuando se conecta la tira LED en serie.
Français:
Pour être conforme aux règles de sécurité, une
source d'alimentation de Classe 2 doit être utilisée.
L'installation ne doit pas dépasser un total de 100W
lorsque les bandes LED sont montées en série.
Utility knife
*Neutral-based electronics grade silicone sealant
844.964.1600
E515294
Silicone Sealant*
info@evoralight.com
Advertisement
Table of Contents
Summary of Contents for evoralight Ethos
- Page 1 Installation Guide Ethos™ Wet Location LED Strip Ethos Wet Location ™ LED Strip E515294 Installation Guide Introduction Welcome to évoralight: Brighter Together. Our premium LED tape lights are designed and manufactured to become purpose-centric lighting solutions. Lighting made for humans, by humans.
- Page 2 Make sure that you have everything you need to complete the installation. Make sure that all components are compatible. Do not exceed the maximum run length of your Ethos™ Wet Location LED Strip, as this may cause voltage drop and unwanted effects.
- Page 3 Installation Guide Ethos™ Wet Location LED Strip Turn Power Off Turn the power off at the circuit breaker to avoid any possible injury. at Circuit Breaker Cut LED Strip to Required Length Measure the tape light to the required length. Using sharp scissors, cut only along the indicated cut marks.
- Page 4 LED Strip to your driver. Turn on the power. The Ethos™ Wet Location LED Turn Power On at Circuit Breaker Strip should light up and work properly.
- Page 5 Complete warranty details for fixtures and additional accessories are available at https://www.evoralight.com/ within the policies section. For warranty related questions please contact our product support team at support@evoralight.com.
- Page 6 Pay attention to the input voltage of the LED strip light and never exceed that voltage, even briefly. Only cut the LED strips on the designated cut markings. Our Ethos™ Wet Location LED Strip is IP67 rated. Please keep in mind that cutting the strip voids the IP rating. Contact 844.964.1600...
Need help?
Do you have a question about the Ethos and is the answer not in the manual?
Questions and answers