Sears 987.889 Owner's Manual page 17

8 horsepower 33-inch mower
Table of Contents

Advertisement

OPERATION
BEFORE STARTING ENGINE
AddMotor Oil
• Only use high quality detergent
oil rated with API service classifica-
tion SF, SG or SH. Select the oil's
SAE viscosity grade according to
your expected operating tempera-
ture. Above 32OF, use SAE 30;
below 32OF, use 5W30.
NOTE: Although multi-viscosity oils
(5W30,.10W30
etc.) improve start-
ing in cold weather, these oils will
result id increased oil consumption
when used above 32OF. Check
engine oil more frequently to avoid
possible engine damage from run-
ning low on oil.
• Be sure that engine is level. Re-
move dipstick (A, Figure 3-10).
• Fill with recommended oil to be-
tween "Full" and "Add" marks on
dipstick (approximately 32 oz.).
Pour slowly and do not overfill.
While pouring, stop frequently, re-
insert dipstick until it is seated
completely, remove and check oil
level. (Wipe dipstick each time be-
fore re-inserting.) Replace dipstick
securely.
• Check oil before each use. Add if
needed.
• Change oil after the first 2 operat-
ing hours and every 25 operating
hours thereafter (more often in ex-
tremely dusty or dirty conditions).
Fill Fuel Tank
• Stop engine and allow it to cool
for three minutes before removing
fuel fill cap (B, Figure 3-10). Do
not check fuel level or add fuel
while indoors.
• Clean area around fuel fill cap
and remove fill cap. Fill gas tank
with clean, fresh unleaded gaso-
line. Do not mix oil with gasoline.
• Using a funnel or spout, fill tank
to 1/2 inches below bottom of fuel
tank filler neck to prevent spills and
to allow for fuel expansion.
• Insta_ll_fillcap securely and wipe
up any Spilled gasoline.
WARNING: Experience indicates
that alcohol blended fuels (gasohol
or using ethanol or methanol) can
attract moistura which leads to
separation and formation of acids-
during storage. Acidic gas can
damage the fuel system of an en-
gine while in storage. To avoid
problems, the fuel system should
be emptied before storage for 30
days or longer. Drain the gas tank,
start the engine and let it run until
the fuel lines and carburetor are
empty. Use fresh fuel next season.
See STORAGE instructions for ad-
ditional information.
Never use en-
gine or carburetor cleaner products
in the fuel tank or permanent dam-
age may occur.
A
B
Figure 3-10
DANGER
Gasolineis highly flammable and its vapors are explosive. Read and fol-
low these precautions to help avoid severe personal injury or property
damage.
• Do not remove gas cap or add gasoline if engine is running or still hot
from operation. Allow engine to cool at least three minutes before
refueling.
• Keep openflame, matches, sparks, or smoking materials away from fuel
tank and fuel container.
• Do not fill fuel tank indoors. After filling, wipe up any spills and move
machineaway from gasoline fumes before starting engine. Securely re-
place the capson the fuel tank and fuel container.
• Do not fill fuel tank completely. Fill tank to 1/2" below bottom of filler
neckto providespace for fuel expansion,
• Store gasolinein anapprovedfuel containerand in a well-ventilated area.
Store it safelyout of the reach of children.
• Do not store gasolinewhere vaporsmay reach an open spark or flame, or
where ignitionsources(suchas hot water heaters, space heaters, furnaces,
clothesdryers, stoves, electric motors, etc.) are present.
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Craftsman 987.889000

Table of Contents