Table of Contents
Advertisement
MAINTENANCE
Cleaning the Machine
To keep your sewing machine operating well, clean it often. No lubrication (oiling) is needed. Wipe the exterior surface of your ma-
chine with a soft cloth to remove any dust or lint built up.
Cleaning the Bobbin Area
Raise the needle and turn off the machine.
Remove the presser foot. Slide off the bobbin cover and re-
move the bobbin.
Clean the feed teeth and the bobbin area with the brush found
among the accessories.
Attach the presser foot, insert the bobbin and replace the bob-
bin cover.
Cleaning under the Bobbin Area
Raise the needle and turn off the machine.
Clean the area under the bobbin case after sewing several
projects or any time you notice an accumulation of lint in the
bobbin case area.
Remove the presser foot. Remove the screws in the needle
plate by using the screwdriver. Lift up and remove the needle
plate.
Remove the bobbin case by lifting it up.
Clean the area with the brush or with a dry cloth.
Note: Do not blow air into the bobbin case area. The dust and
lint will be blown into your machine.
Guide the "forked" end of the bobbin case (A) under the feed
teeth from left to right. The bobbin case should be placed uder
the feed teeth and under the spring (B). The mark (C) on the
bobbin case should be aligned with the mark (D) on the the
hook race for easy placement. Move the bobbin case slightly
until it slips correctly into the hook race (E). To make sure the
bobbin case is properly replaced, turn the handwheel towards
you. The hook race should rotate freely in a counter-clockwise
direction.
Place the needle plate over the feed teeth, replace and tighten
the screws.
Attach the presser foot and replace the bobbin.
18
English
A
B
E
C
D
Advertisement
Table of Contents
