TeeJet 845-AB Quick Start Manual

RE FER E NC E GUI D E
845-AB SPRAYER
QUICK START GUIDE
POWER
Power On the Console
To power on the console:
1. Press and release the PROGRAMME
The console will initially display the software version at the top of
the screen and the serial number of the console at the bottom of the
screen. After approximately 3 seconds, the console will enter the
work screen.
APPLICATION MODE
The 845-AB gives the possibility of working in two different ways
to fit the application. Therefore, the console should be set up and
consequent programming and working features will be dependant
of the chosen mode.
Airblast Mode
This mode is designed to work with Airblast sprayers, mostly
spraying on two sides (left and right) with the possibility to switch
on or off sections in the height. The working width is defined by
the distance between two rows of trees. This mode is called AB
(airblast).
Figure 1: Airblast (AB) principle
-2-L
-1-L
button.
-2-R
-1-R
Working Width
Power Off the Console
To power off the console:
1. While pressing and holding the MINUS
release the PROGRAMME
2. Release the MINUS button.
The console will save new information (area and volume counters)
to memory before it powers down. Pressing any key during the
power off count down will cancel the shut off function.
Automatic Shutdown
With the Master Switch in the "OFF" position, the console will
automatically shut down after 10 minutes of no inputs (or at the time
specified in the Automatic Shutdown Time setting in the OEM Setup
Mode).
High Clearance / Vineyard Mode
This mode is designed to work with vineyard sprayers that are
spraying horizontally. Several rows are covered and sections can
be switched on or off to adapt the working width. Each section
covers a number of faces. The working width is defined by the
number of faces and the row width.
One or more nozzles can be spraying each face. If all nozzles
spraying on a face are not equal, they should be considered
as a unique nozzle and the total flow has to be set up in the
configuration menu. But all faces have to be sprayed equally. This
mode is called HC (high clearance / vineyard).
Figure 2: High Clearance / Vineyard (HC) principle
Section 1 Section 2
3 Faces
Face
Working Width
button, press and
button.
Section 3
4 Faces 3 Faces
Row Width
98-01611-EN R0
1