Advertisement
Available languages
Available languages
3)
Cut a proper long piece of pipe and connect with the inlet port. Put the filter onto
the other end of the pipe.
4)
Connect the water level detector into port on the pump, then tie the other end of
the detector together with the filter. Throw them into the water container.
5)
Cut the pipe into pieces and use the connectors to connect each pieces of pipe and
the dripper to build the irrigation pipeline system.
6)
Cut one piece of pipe and install the anti-backflow valve to start end of the
irrigation system to avoid backflow. After finishing installation, connect the
irrigation system with the outlet port on the pump
Accessories List
Plumbing connection fittings:
Advertisement
