Advertisement
Introduction
Thanks for choosing Vision's Z-Wave USB dongle of the home automation device. This
TM
USB dongle is a Z-Wave
enabled device (interoperable, two-way RF mesh networking
technology) and is fully compatible with any Z-Wave
TM
powered Z-Wave
enabled device acts as a signal repeater and multiple devices result
in more possible transmission routes which helps eliminate "RF dead-spot". Z-Wave
enabled devices displaying the Z-Wave
manufacturer, and ours can also be used in other manufacturer's Z-Wave
networks. This USB dongle which compliant to ZDK6.XX and above exports Z-Wave
Serial API through a USB CDC/ACM compliant connection with a USB A Plug. A
PC/Notebook which runs Z-Wave software can control Z-Wave Home Area Network
through this USB dongle.
Product Description and Specification
Specification:
TM
Protocol: Z-Wave
(ZM5101A)
Frequency Range:
865.22MHz (ZU1401IN-5)
868.10MHz (ZU1401MY-5)
868.42MHz (ZU1401EU-5)
869.00MHz (ZU1401RU-5)
908.42MHz (ZU1401US-5)
916.00MHz (ZU1401IL-5)
919~923MHz (ZU1401KR-5)
919.80MHz (ZU1401HK-5)
922~926MHz (ZU1401JP-5)
921.42MHz (ZU1401BR-5)
Operating Range.: Up to 100 feet line of sight
Operating Temp.: -15°C~ 60°C (5°F~140°F)
According to Directive 2014/53/EU (RED Directive) the following information shall be
included: The frequency and maximum transmitted power in EU are below:
868.40 – 868.42 MHz: -13.77 dBm
ZU1401EU-5:
Operation
TM
If you are installing the entire Z-Wave
TM
guide of Z-Wave
Interface Controller before installing ZU1401-5 USB dongle
TM
enabled network. Every main
TM
logo can also be used with it regardless of the
TM
Package Content:
1pc ZU1401-5 USB Dongle
1pc User Manual
system for the first time, please refer to the installation
-1-
As the device export a USB CDC/ACM compliant interface, it appears as a serial port which uses
the existing standard driver on most of popular PC/Notebook operating systems.
1.
Simply plug this USB dongle in PC/Notebook USB port.
2.
System requirement：
- Windows 2000/XP/Vista/7 32&64 bit
UZB.INF is provided that reuses the standard Windows usbser.sys or usbser64.sys driver
- Linux kernel 2.6.24+
TM
The device appears as "/dev/ttyACMxx" where xxx is the tty number assigned by the OS
- MAC OS X 6.4
The device appears as "/dev/tty.usbmodemxxx" where xxx is the tty number assigned by the OS
enabled
3.
Support OTW (Over the Wire) Function.
4.
Support IMA (Installation Maintenance Application) Function
Federal Communications Commission Statement
This equipment has been followed to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver,
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Limited Warranty
Vision Guarantees that every USB Dongle is free from physical defects in material and workmanship
under normal use for one year from the date of purchase. If the product proves defective during this
one-year warranty period, Vision will replace it free of charge. Vision does not issue any refunds. This
warranty is extended to the original end user purchase only and is not transferable. This warranty
does not apply to: (1) damage to units caused by accident, dropping or abuse in handling, or any
negligent use; (2) units which have been subject to unauthorized repair, taken apart, or otherwise
modified; (3) units not used in accordance with instruction; (4) damages exceeding the cost of the
product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost.
For information on addional devices, plesae visit us at
CE Declaration of Conformity
Hereby, Vision Automobile Electronics Industrial Co., Ltd. declares that the radio equipment type
ZU1401EU-5 is in compliance with Directive 2014/53/EU.The full text of the EU declaration of
conformity is available at the following internet address:
http://www.visionsecurity.com.tw/index.php?option=module&lang=en&task=pageinfo&id=46&index=2
www.visionsecurity.com.tw
-2-
Advertisement
