Mitsubishi Electric NTXAMT36A112AA Installation Manual page 9

– Ask an authorized technician to install the accessories. Improper installation by the
user may result in water leakage, electric shock, or fire.
• If refrigerant gas leaks during installation work, ventilate the room.
– If the refrigerant gas comes into contact with a flame, poisonous gases will be
released.
• Securely install the outdoor unit terminal cover (panel).
– If the terminal cover (panel) is not installed properly, dust or water may enter the
outdoor unit and fire or electric shock may result.
• If the air conditioner is installed in a small room, measures must be taken to prevent the
refrigerant concentration from exceeding the safety limit even if the refrigerant should
leak.
– Consult the dealer regarding the appropriate measures to prevent the safety limit from
being exceeded. Should the refrigerant leak and cause the safety limit to be
exceeded, hazards due to lack of oxygen in the room could result.
• After completing installation work, make sure that refrigerant gas is not leaking.
– If the refrigerant gas leaks and is exposed to a fan heater, stove, oven, or other heat
source, it may generate noxious gases.
• Children should not be allowed around the air conditioning equipment.
• The installer and system specialist shall ensure there is no refrigerant leakage according
to local regulations and standards.
• Pay special attention to the location the unit is installed in. Refrigerant is heavier than air
so locations such as basements or crawlspaces where refrigerant can accumulate can
become dangerous.
• The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
• Do not use refrigerant other than the type indicated in the manuals provided with the unit
and on the nameplate.
– Doing so may cause the unit or pipes to burst, or result in explosion of fire during use,
during repair, or at the time of disposal of the unit.
– It may also be in violation of applicable laws.
– MITSUBISHI ELECTRIC CORPORATION cannot be held responsible for malfunctions
or accidents resulting from wrong type of refrigerant used.
Specifications are subject to change without notice.
NTXAMT12, 18, 24, 30, 36A112AA
9 © 2020 Mitsubishi Electric Trane HVAC US LLC. All rights reserved.