5. Set and programme the individual address in the ETS. (Programming LED turns off) 6. Configure and programme the settings in the application programme. MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de...
■ not sent repeatedly. ■ sent up to three times repeatedly. ■ sent once repeatedly. ■ MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de 6 / 14...
Page 7
For more information on “Group telegrams” and “Physical telegrams”, see 4.2 Telegram routing MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de 7 / 14...
The setting “route all” for group and physical telegrams is only intended for test purposes. The setting in normal operation is not recommended. MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de...
(abbreviated as “RF” in the following) to TP must be implemented via the RF-LK001.03 line coupler. A radio line is generated in the medium “RF”. Here, too, the RF line coupler has the address “x.0”.
Therefore, only group addresses that are really needed should be added to the filter table. MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de...
If changes are made to the topology of the project, the line coupler must be reprogrammed first and then all devices affected by the change in topology. MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de...
Use in the USA and Canada is not permitted! 6.4 History V1.0 First Version of Technical Manual DB V2.0 08/2023 MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de 14 / 14...