Sumake SA-2362A Quick Start Manual

SA-2362A, SA-2382A
AIR FILTER, REGULATOR & LUBRICATOR (AUTO DRAINER)

Description:

The filter/regulator/lubricator is a three part system. The filter is designed to remove most liquid and solid particles from the air supply.
The self-relieving pressure regulator is used to adjust the outlet pressure. The lubricator provides oil to the air tool and increases the life of the tool.

Specifications:

Max. Temperature . . . . .60℃ / 140℉
Auto drain:
Set Pressure . . . . . . . . . . . 7~175 psi
Set Pressure . . . . . . . . . . . 0.5~12Bar
Manual drain:
Set Pressure . . . . . . . . . . . 7~215 psi
Set Pressure . . . . . . . . . .0.5~14.8Bar
Air Inlet/outlet . . . . . . 1/2"、3/4"、1/2"
Gauge Ports . . . . . . . . . . . . . . . . .1/4"

Unpacking:

After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Make sure to tighten fittings, bolts, etc., before
putting unit into service.

Safety Guidelines:

This manual contains information that is very important to know and understand.
This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following
symbols.
Danger:
Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
Warning:
Warning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
Caution:
Caution indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

General Safety Information:

This product is a part of a high pressure system and the following safety precautions must be followed at all times along with any other existing
safety rules.
Read this instruction manual before installing this device to the air supply system. Be thoroughly familiar with
the controls and the proper use of the equipment.
1. Safety glasses must be worn during operation. Always work in a well ventilated area.
2. Do not exceed any pressure rating of any component in the system.
3. Protect air lines from damage and/or punctures.
4. Check air hoses for weak or worn condition before each use. Make sure all connections are secure.
5. Keep all nuts, bolts and screws tight and ensure equipment is in safe working condition.
Danger:
This product is specifically designed for compressed air service ONLY. Use with any other material (liquid or gas) is a misapplication and not
permitted. Use or injection of certain hazardous liquids or gases in the system (such as oxygen, alcohol or liquid petroleum gas) will harm the unit
and result in a combustible condition or hazardous external leakage. misapplication will void all warranties and manufacturer's responsibilities.
1
SA-2362(82)A-I-1911A-HB