Download Print this page

Advertisement

Quick Links

Please read the instruction manual carefully before using this product so that the installation of
the app and the setup of the watch can be performed correctly.
- To switch on the device, press the "ON/OFF" button for a few seconds.
- You must insert a SIM card to be able to use all the functions of the watch.
- Turn off the smartwatch, make sure the watch is switched off before inserting the card.
- We cannot be held responsible for possible faults due to incorrect configuration of the SIM card.
incorrect configuration of the SIM card. In case of doubt, please contact your telephone
1. Preparation before use
(1) Check that all accessories are complete and that the device model is correct.
(2) Choose the SIM card that matches the GSM network, you can consult your phone operator.
(3) The SIM card is required to access the GPRS function and call screening function.
2. Install the SIM card please select a 2G SIM card of GSM network, this card is needed to
enable caller ID function, GPRS data traffic (Internet access function), call function.
Note: This watch can only support 2G data stream. Install your SIM card in power off state and
then power on the watch, thus avoiding SIM card damage.
SmartWatch infantil – Q13
Quick Start Guide
Before first use:
- Charge the battery for at least two hours.
-
Attention: the SIM card must not have a PIN code.
your telephone company to configure the SIM card.
SIM card

Advertisement

loading

Summary of Contents for Infantil Q13

  • Page 1 SmartWatch infantil – Q13 Quick Start Guide Please read the instruction manual carefully before using this product so that the installation of the app and the setup of the watch can be performed correctly. Before first use: - Charge the battery for at least two hours.
  • Page 2 3.Turn On / Turn off Turn on: Hold press the power button if the watch was turned off. Turn off: Only can remote turn off the watch when the watch is in normal working state. If the SIM card isn't installed or don't connect with APP, you can hold press the power button to turn off.
  • Page 3 After register, Log in. 5.3 APP account bind with watch Bind with the watch after registered successfully. Scan or input 15 bytes register code. The register code can be found on App download interface in the watch. Then enter the Bind setting. 6.
  • Page 4 SMS Alerts setting: set SMS alarm switch for low power, and SOS . The number set in the APP receiving the SMS, the cost is same with normal SMS, this number is also the monitoring number by default Family member: display all family members whom bind with the watch. Switch setting: switch some functions Work mode: 3 work modes optional, default normal mode.