Tail Wheel (Lift Type); Replace Wheel; Replace Pivot; Wheel Bearings (Pull Type) - EVH MFG HARDEE 1198W Operator And Maintenance Manual

MAINTENANCE

TAIL WHEEL (LIFT TYPE)

Replace Wheel

Caution
Adequately support the mower and the wheel before
removing the axle. Both the wheel and the mower are
heavy and could cause damage to the mower or serious
injury if dropped.
 Remove wheel axle nuts and axle.
 Remove wheel.
 Position wheel in pivot yoke.
 Install wheel axle and nuts.

Replace Pivot

 Raise and support mower using approved means.
Support mower high enough so that pivot shaft can
be removed from tail wheel pivot bracket.
Caution
Adequately support the mower and the tail wheel
assembly before removing the bolt. Both the tail wheel
and the mower are heavy and could cause damage to
the mower or serious injury if dropped.
 Remove collar bolt, nut and collar on top of pivot
bracket.
Removing Tail Wheel Pivot Collar Bolt
 Remove pivot from pivot bracket.
 Install replacement pivot in bracket.
 Install collar, collar bolt, and nut on pivot on top of
pivot bracket.
 Lubricate with lithium EP grease (See
LUBRICATION, Section 3).
1198W MULTI-SPINDLE ROTARY MOWER

WHEEL BEARINGS (PULL TYPE)

 Remove dust cap from wheel hub.
Clean out old grease from dust cap.

Pack dust cap with clean wheel bearing grease.

 Install dust cap.
13
Hardee by EVH