Sears 917O251550 Owner's Manual page 25

SERVmCE
ADJUSTMENTS
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 33)
The throttle control has been preset at the factory and
adjustment should notbe necessary Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
, With engine not running, move throttle control lever to
fast ('¢e_) position.
- Check that speed control lever is against stop screw. If
it is not, loosen casing clamp screw and pull throttle
cable until lever isagainst screw. Tighten clamp screw
securely.
IDLE FUEL
ADJUSTING
SCREW
IDLE SPEED
ADJUSTING
SCREW
THROTTLE
CONTROL
CABLE
STOP
SCREW
CLAMP
SCREW
CHOKE
CONTROL
CABLE
TO ADJUST CHOKE CONTROL
(See Figs. 33 and 34)
The choke control has been preset at the factory and
adjustment should not be necessary, check adjustment as '.
described below before loosening cable_ If adjustment is
necessary, proceed as follows:
• With engine not running, move choke control (located
on dash panel) to full choke
(1",,I)
position.
° Remove air cleaner cover, filter and cartridge plate to
expose carburetor choke (See "AIR FILTER" in the
Customer Responsibilities section of this manual).
• Choke should be closed. If it is not, loosen casing
clamp screw and move choke cable until choke is
completely closed. Tighten casing clamp screw se _
curely.
• Reassemble air cleaner.
CLOSED FOR
FULL
FIG. 34
FIG. 33
25