Table of Contents
Advertisement
Installing / Removing the Stand
The LCD display is very fragile, and must be protected at
all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could
scratch or damage the LCD display, comes into contact
with it. DO NOT exert pressure on the front of the TV at any
time because the screen could crack.
Fitting the Feet
1. Ensure the TV is switched off and not connected to the
mains power supply.
2. Lay the TV down on a flat surface ideally on the edge of a
table so the base of the TV slightly overhangs the edge of
the table, with the back side facing up. Please make sure a
soft cushioned material (such as a dry bath towel or thick
piece of foam) is placed beneath the screen.
3. Position the each foot onto the back of the stand. They are
marked Left and Right on the back of each foot. Make sure
you slide the lug under the recess.
4. Using 3 of the supplied screws, to screw each foot onto the
TV.
LT-55C860(A)_IB.indd 11
Preparation
When you remove the TV from its box lie it flat.
Don't balance it on the sensor at the front of the TV.
Left foot
Cushioned
material
2
Right foot
Table
11
27/04/2017 14:44
Advertisement
Table of Contents
