Page 1
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo This manual MUST be given to the user of the product. BEFORE using this product, this manual MUST be read and saved for future reference.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 1.2 Symbols in this manual 1 General Symbols and signal words are used in this manual and apply to hazards or unsafe practices which could result in personal 1.1 Introduction injury or property damage.
General Warranty claims can only be made through the provider • Difficulty standing or keeping their balance from whom the product was obtained. • Weak legs or lower limb disability • Medical conditions that impair their balance 1.4 Compliance The product is intended for institutional and private house Quality is fundamental to the company’s operation, working hold use.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 2 Safety WARNING! Risk of injury – Do not use if defective. 2.1 Safety information – In the event of a malfunction, contact your provider immediately. WARNING! – Do not make any unauthorized changes or Risk of injury or damage alterations to the product.
Page 7
Safety Labels on the product Product designation Reference number The following label is attached to the backside of the headrest: Serial number Label Description Maximum user weight CAUTION! Date of manufacture Risk of impact Read user manual Your body can be hit by the Conformity mark backrest/headrest when pulling Note (use only on flat surfaces)
Page 8
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo The following label is attached to the handle of the Activation handle for seat tilting. backrest: Label Description WARNING! Risk of tipping over – Do not step on the footrest...
Allen key Rear antitipper with screw, washer and mounting cap (2x) (Ocean Dual VIP Ergo only) Brake cover (2x) Brake lever cover (2x) Clamping protection cover (2x) Push bar Head support Ocean VIP Ergo: Backrest with backrest cover and armrests 1639504-C...
Page 10
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo Accessory — Toilet pan holder with toilet pan Toilet pan holder Toilet pan 1639504-C...
Setup 4 Setup The seat height must be adjusted on both sides simultaneously. 4.1 Safety information WARNING! – Check the parts for transport damage before commissioning and contact your provider if required. – Ensure during assembly that the parts are positioned correctly with respect to one another.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo The seat height can be adjusted to accommodate different situations of use e.g. transfer from a bed or a wheelchair or use above toilet etc. 4.2.2 Installing the backrest WARNING! –...
Setup 4.2.3 Installing the activation handle WARNING! Risk of injury due to damaged backrest buckles! Check for secure fastening of the backrest buckles each time the product is maintained or reconditioned. – Check all buckle clips for secure fastening by closing the buckles and pulling on both ends.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 2. Unscrew the screws B of the armrest bracket A using For the Ocean Dual VIP Ergo, the activation handle E the Allen key supplied. for backrest tilting is already installed to the left side 3.
Setup 4.2.6 Installing the footrests 1. Slightly pull up the footrest B. 2. Pull the clip G out of the hole in the footrest and re-insert it into the required hole. Pull out the footrest slightly further if necessary. 3. Push down the footrest until the groove A catches the pin of the clip.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 1. Use the star handle F to insert the screw a little into 4.2.8 Installing the rear antitippers the bracket G. WARNING! 2. Push the bracket with the screw onto the handle of the...
Setup 4.2.9 Installing/removing the brake covers / clamping 1. Attach the brake lever cover A by pinning up the slot protection covers B to the small shaft C. 2. Position the lower part of the brake cover D at an angle from below over the brake housing E.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 3. Engage the front part of the toilet pan holder with the 5 Accessory (optional) front cross tube D. 4. Re-fit the seat to the frame. WARNING! 5. Place the lid on or remove it from the toilet pan.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 6 Usage WARNING! Risk of tipping – Swivel the footrests to the side or fold up the 6.1 Safety information foot plates before sitting down or standing up. – Before sitting down or standing up, turn the...
Usage WARNING! IMPORTANT! Risk of tipping Risk of damage to the product – The shower and toilet commode must only be – Do not lift the shower and toilet commode moved by using the push bar. using the footrests, armrests or any accessories. For users with high risk of standing on the CAUTION! footrests (e.g.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 6.3 Swivelling the footrests Removing/fitting the heel strap 1. Open the hook and loop strip E on the heel strap. 2. Remove the screw F from the underside of the foot plate.
Usage For the two lowest seat heights, the complete CAUTION! adjustment range of the footrest can not be used. Risk of crushing Before use, check that the footrests do not touch Your fingers or hands can get caught and the floor when tilting the seat forwards. If necessary squeezed by the tilting mechanism.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo Increased force is needed for tilting backwards without seated user. Automatic tilting upwards without seated user when activation handle is pulled. 6.6 Engaging/disengaging the castor locks CAUTION! Risk of trapping/squeezing All castor locks are foot-operated.
Transport 7 Transport 7.1 Safety information The product can be dismantled for transport into the parts of the scope of delivery, see chapter 3 Components, page 9 . 1. Disassemble the product: Refer to chapter 4 Setup, page 11 by following the assembly steps in reverse order. IMPORTANT! Risk of damage to the product –...
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 8.2 Cleaning and disinfection 8 Maintenance The product can be cleaned and disinfected using 8.1 Maintenance and inspection commercially available agents. The product is maintenance-free, provided the cleaning and IMPORTANT! safety instructions outlined below are adhered to.
Page 27
Maintenance 4. Remove the brake covers and clamping protection IMPORTANT! covers, see chapter 4.2.9 Installing/removing the brake Risk of damage covers / clamping protection covers, page 17. – Washing at higher temperatures can cause 5. Wipe down the individual parts using a cloth or damage.
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo handling in each country. Contact your local waste 9 After Use management company for information. 9.1 Storage WARNING! Risk of damage to the product – Store the product in a dry area.
Troubleshooting 10 Troubleshooting 10.1 Identifying and repairing faults The following table provides information on malfunctions and their possible causes. If you cannot correct the malfunction using the solutions named, contact your provider directly. Malfunction Possible cause Solution Difficulty in adjusting the seat height Dirt between the seat frame and the Disassemble the base frame and clean side part...
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo 11 Technical Data 11.1 Dimensions and weight Ocean VIP Ergo Ocean VIP Ergo XL Ocean Dual VIP Ergo 480 mm 480 mm 475 mm – 600 mm 533 mm – 658 mm...
Page 31
Technical Data Ocean VIP Ergo Ocean VIP Ergo XL Ocean Dual VIP Ergo ca. 1052 mm – 1340 mm (in neutral seat position) ca. 1052 mm – 1202 mm (in neutral seat position) 1000 mm 742 mm 160 mm 213 mm / 251 mm / 289 mm 319 mm –...
Aquatec® Ocean VIP Ergo / Aquatec® Ocean Dual VIP Ergo Ocean VIP Ergo Ocean VIP Ergo XL Ocean Dual VIP Ergo 1290 mm Reversing width 1140 mm Product weight 23.5 kg 23.5 kg 28.3 kg Maximum user weight 150 kg 11.2 Materials...
Page 33
1639504-C 2019-01-30 Making Life’s Experiences Possible® *1639504C*...
Need help?
Do you have a question about the Ocean VIP Ergo and is the answer not in the manual?
Questions and answers