Prima PS-42D8 B Service Manual page 8

Based on the features of computer set up the serial port (COM Port) and select corresponding
serial port (if it's not possible to burnt-write other serial port can be used instead). Baud-select
115200 and then select Reset Target After Download. Hit flash press button and it's ready to
operate. For the setup of other items please refer to the figure above (already defaulted by the
system so it's normally unnecessary to alter)
1. Switch on PDP and it begins to run the burnt-write program;
2.Once it's over with burnt-write, the cancel pushbutton will become flash. Switch off the
main power and then to switch on the TV set again.
Note: Do not switch the power or the set off in the course of burnt-writing. Otherwise it
may result in the inability of the flash to burnt-write again.
6