Summary of Contents for IMMO EFI PGR02
- Page 1 EFI TECHNOLOGY PGR02 / PGS02 PGN04 / PGR04 / PGZ04 PGS06 For ASW-NEXT Short User Manual October 2023 Technical support: asw_support@immo-tools.lt...
- Page 2 REPROG mode or when supply voltage is lower than 10V or higher than 14.4V You can suspect internal hardware fault of EFI TECHNOLOGY control unit if ignition voltage displayed in troubleshooting information significantly differ from the real voltage of power supply. Minor difference (+/-0.6V) is allowed. Technical support: asw_support@immo-tools.lt...
- Page 3 1. How to connect? Technical support: asw_support@immo-tools.lt...
- Page 4 Write value of any active (marked with green) key to transponder T5 as TEMIC-11 using any suitable transponder programmer. Choose data with header „BE FA“ or „7D 5F“ depending on type of your transponder programmer. Technical support: asw_support@immo-tools.lt...
- Page 5 – no data displayed value as in conversion of any kind is required. the picture above. Software will automatically re-allign bits and now it looks like this: Technical support: asw_support@immo-tools.lt...
- Page 6 Press button „Reset to VIRGIN“ ➢ You want to check how many keys programmed to the CDI unit • Press „Read Identification“ button to read HW / SW info along with number of keys programmed to the control unit Technical support: asw_support@immo-tools.lt...
- Page 7 Programming procedure closed. NOTE: Do not exceed time of 1.5 seconds when changing key in ignition lock between every step. *- Depends on type of transponder programmer (does it use BE FA or 7D 5F header) Technical support: asw_support@immo-tools.lt...
- Page 8 MAP file. NOTE: Do not edit data at 0080-008F. MAP file will be treated as corrupted once data at line 0080 was modified. AREA FOR USER NOTES DO NOT EDIT THIS LINE Technical support: asw_support@immo-tools.lt...
- Page 9 • IMMO-OFF / IMMO-ON This function configures immobilizer feature presence. Works by K-Line. Technical support: asw_support@immo-tools.lt...