Summary of Contents for Crystal Clean 1684
- Page 1 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 USER MANUAL MODEL 1684 AUTOMATIC SPRAY GUN CLEANER Heritage-Crystal Clean, LLC 2175 Point Blvd. Ste 375 Elgin, IL 60123 Tel. 1-877-938-7948 REV 2019-06...
-
Page 2: Common Features
MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 INTRODUCTION Every machine is tested for compliance with Quality Assurance standards. Follow the directions in this manual under SETUP, OPERATION and MAINTENANCE in order to operate this machine safely and effectively. Not following these instruction can lead to malfunction or damage to the machine. - Page 3 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 HCC75W HCC75W Hood Spigot Brush Blow Gun Automatiic Tank Manual Tank Vent Control Timer Air Rinse Clean Rinse Drain Valve (inside) Drain Hose Rinse Pump and Suction Hose for Spigot. Suction Hose and Brush...
-
Page 4: Air Supply
MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 ACCESSORIES: See below. ACCESSORIES PART NO. 1 MANUAL 1 TRIGGER CLAMP & PLUG KIT, SET OF 2 140-2340 1 AIR BLOW GUN (INSTALL ON RIGHT SIDE OF UNIT) 102-7010 1 VENT AND HOOD DOOR SUPPORT... - Page 5 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 • The vent kit is located in a box in the cabinet. Locate the hole for the vent on the underside of the top of the cabinet. See photo to the right and below, left.
- Page 6 • Heritage-Crystal Clean provides a wash pail and a clean pail. The wash pail has 3 gallons of solvent and the clean rinse pail has 5 gallons of solvent. Place the wash pail on the left side in front of the cabinet and the rinse pail on the right side.
- Page 7 Stretch the 3" diameter aluminum vent hose. Use the clamp to attach this vent hose to the solid vent tube at the top of the cabinet of the 1684. The other end of the vent hose is connected to the venting system.
- Page 8 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 TRAY TO HOLD NOZZLE EXTENSIONS (left side of tank) DIFFERENT TYPES OF SPRAY GUNS ON NOZZLE EXTENSION...
- Page 9 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 PREVENT SOLVENT FROM ENTERING THE AIR PASSAGE OF THE SPRAY GUN • Insert the plastic plug into the air fi tting as in the photo at right. • Positive air will fl ow through the passage way during cleaning.
- Page 10 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 MAINTENANCE • Clean the stainless steel inlet fi lter each month. Procedure: Follow step 1 and step 2 below under REPLACING SOLVENT. Lift the suction pipe from the wash pail, (see the left photo below) unscrew the stainless steel fi lter from the nut, by hand, and clean it with clean solvent.
-
Page 11: Troubleshooting
MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 TROUBLE SHOOTING PROBLEM REASON CORRECTIVE ACTION Open drain valve (put in vertical posi- Drain valve closed tion), if not already open PUMP MAKES PUMPING Check wash liquid level. Add liquid if Liquid level too low SOUND BUT LIQUID DOES less than1/2 full. - Page 12 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 PROBLEM REASON CORRECTIVE ACTION Wash solvent is contaminated GUNS NOT CLEAN, WASH Replace cleaning agent with water SOLVENT IS MILKY WHITE Replace or recycle wash solvent. Use SOLVENT APPEARS RED OR Water in solvent is corroding the...
- Page 13 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 UDP2TA: • Remove the suction tube from the pail and blow air at 85 PSI into the INLET Sovent Hose. Step on the foot pedal to activate the pump for the brush. This procedure may have to be repeated several times.
- Page 14 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06...
-
Page 15: Replacement Parts
MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 REPLACEMENT PARTS ACCESSORIES PART NO. VENT AND HOOD DOOR SUPPORT 780-3723 140-2340 TRIGGER CLAMP & PLUG KIT, SET OF 2 780-3530 INSTALLED NOZZLE EXTENSION TO CLEAN DISPOSABLE CUPS 102-7010 AIR BLOW GUN (INSTALL ON RIGHT SIDE OF UNIT) 780-524/112-261 3"... - Page 16 MANUAL - 1684 SPRAY GUN CLEANER REVISED 2019-06 REPLACEMENT PARTS 1684...
- Page 17 Consumable Items are not covered by this warranty (eg: gaskets, screens, bags, filters, nozzles and air jets). This warranty replaces all other warranties expressed or implied by statute or otherwise. To make a claim, call Heritage-Crystal Clean Service at 1-877-938-7948 and quote the serial number of the unit.
Need help?
Do you have a question about the 1684 and is the answer not in the manual?
Questions and answers