LG FC1410S2W Owner's Manual page 42

Symptoms
Water in the
washing machine
does not drain or
drains slowly
Washing
machine does
not start
Washing
machine will not
spin
Door does not
open
Wash cycle time
delayed
Fabric softener
overflow
Softeners
dispensed too
early
The buttons may
not function
properly.
42
Reason
Drain hose is kinked or clogged.
The drain filter is clogged.
Electrical power cord may not be
plugged in or connection may be
loose.
House fuse blown, circuit breaker
tripped,or a power outage has
occurred.
Water supply tap is not turned on.
Check that the door is firmly shut.
Once washing machine has started,
the door cannot be opened for
safety reasons.
If an imbalance is detected or if the
suds removing programme is on,
the wash time will increase.
Too much softener may cause an
overflow.
Too much softener may cause an
premature dispensing.
The button cannot be recognized
when the door is open.
Solution
• Clean and straighten the drain hose.
• Clean the drain filter.
• Make sure plug fits tightly in wall
outlet.
• Reset circuit breaker or replace fuse.
Do not increase fuse capacity. If
problem is a circuit overload, have it
corrected by a qualified electrician.
• Turn on water supply tap.
• Close the door and press the Start/
Pause button. After pressing the
Start/Pause button, it may take a
few moments before the washing
machine begins to spin. The door
must be locked before spin can be
achieved. Add 1 or 2 similar items
to help balance the load. Rearrange
load to allow proper spinning.
• Check if the 'Door Lock' icon is
illuminated. You can safely open the
door after the 'Door Lock' icon turns
off.
• This is normal. The time remaining
shown in the display is only an
estimate. Actual time may vary.
• Follow softener guidelines to ensure
appropriate amount is used. Do not
exceed the maximum fill line.
• Follow the guidelines provided by the
detergent manufacturer.
• Close the dispenser drawer slowly.
Do not open the drawer during the
wash cycle.
• Press again after closing the door.
EN