Honeywell HW-T12341 User Manual page 6

USER SERVICING INSTRUCTIONS (CONTINUED)
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that
should not be removed. Discard product if the attachment plug is damaged.
B) Replace the fuse of the tree top connector power cord plug 2:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug
by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards
blades.
3. Remove fuse carefully.
4. Risk of fire. Replace fuse only with 3 Amp, 125 Volt fuse (provided
with product).
5. Close fuse cover. Slide closed the fuse access cover on top of
attachment plug.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse)
that should not be removed. Discard product if the attachment plug is damaged.
Replace the lamp:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug
by pulling on cord.
2. Unlock the burned out LED lamp by lifting the hook.
3. Pull lamp and plastic base straight out of lampholder.
4. Replace lamp with only 3.0 Volt, 0.06 Watt, LED type lamp (provided with
product). Always match the hook to the tab.
5. Lock the hook of lamp base by pushing lock down into the tab.
CAUTION:
1. To reduce the risk of overheating, replace burned-out lamps promptly. Use
3.0 Volt, 0.06 Watt LED lamps only.
deliberately change the direction of the LED lamp in the lamp holder.
2. Risk of fire. This product does not contain lamp shunts, which allow the
product to operate if one lamp burns out. Replace lamps only with the
spare lamps provided with this product.
Unlock
EN
Hook
Lock
Tab
The LED lamp has polarity. Do not
6