Hayward OmniLogic HLX-LCD Installation Manual
Hayward OmniLogic HLX-LCD Installation Manual

Hayward OmniLogic HLX-LCD Installation Manual

Replacement touchscreen for omnilogic

Advertisement

092675 RevC
OmniLogic
Replacement touchscreen for OmniLogic
Installation Manual
Contents
Description............................1
Installation............................1
HLX-LCD
HLX-LCD0520
Hayward Industries
400 Connell Drive, Suite 6100
Berkeley Heights, NJ 07922
Phone: (908) 355-7995
www.hayward.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OmniLogic HLX-LCD and is the answer not in the manual?

Questions and answers

Summary of Contents for Hayward OmniLogic HLX-LCD

  • Page 1 092675 RevC OmniLogic Replacement touchscreen for OmniLogic Installation Manual Contents Description......1 Installation......1 HLX-LCD HLX-LCD0520 Hayward Industries 400 Connell Drive, Suite 6100 Berkeley Heights, NJ 07922 Phone: (908) 355-7995 www.hayward.com USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 2 1. Ensure that power is removed from OmniLogic. 2. Remove the dead front to expose the OmniLogic Main Board. Remove the Local Terminal by first unplugging its ribbon cable. Unplug Local Terminal ribbon cable USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 3 With the MSP Local Terminal removed, you'll be able to gain access to the circuit board. Flip the MSP so you can see the underside. WARNING: before going further, read steps 5 and 6 and refer to the their diagrams. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 4 Once the latch is released, gently pull the ribbon cable straight out from the connector. Wing Wing Carefully use fingernail or included plastic washer tool to lift the connector latch by the wings. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 5 12. The OmniLogic should return to normal operation with no configuration needed. The last step is to calibrate the new touchscreen. Refer to the following screens. Once calibration is com- plete, the system will automatically power cycle. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 6 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 7 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 8 Hayward is a registered trademark and OmniLogic is a trademark of Hayward Industries, Inc. © 2017 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective owners. Hayward is not in any way affiliated with or endorsed by those third parties.

This manual is also suitable for:

Omnilogichlx-lcd0520

Table of Contents