Advertisement
Quick Links
Advertisement
Summary of Contents for KANG Industrial HB-10
- Page 1 HYDRAULIC PIPE BENDER Model: HB-10 OPERATION MANUAL...
-
Page 2: Safety Warnings And Cautions
I. SAFETY WARNINGS & CAUTIONS WARNING: When using tool, basic safety precautions should always be followed to reduce the Read all instructions before using this tool! risk of person injury and damage to equipment. 1. Keep work area clean. Cluttered areas invite injuries. 2. - Page 3 labels on prescriptions to determine if your judgment of reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool. II WORK PRINCIPLE FIGURES 1. OPERATION HANDLE 2. PLUNGER 3. SEALING O-RING 4. CYLINDER CAP 5.
-
Page 4: Operatiing Instructions
Diameter Outside dia. Max. thickness Radius Bending angle 1/2” 21.30mm 3.25m 62mm 0-90 3/4” 26.80mm 3.50mm 78mm 0-90 1” 33.50mm 4.00mm 98mm 0-90 1-1/4” 42.30mm 4.00mm 128mm 0-120 1-1/2” 48.00mm 4.25mm 148mm 0-120 2” 60.00mm 4.50mm 187mm 0-120 IV OPERATIING INSTRUCTIONS 1. -
Page 5: Parts List
9. If the truck piston (No. 11) can’t bounce back after being pressed down, you may check the oil lever to see if it complies with G.D. standard. You shall also check the spring (No. 6) to see if it is damaged. Then you may fill up the oil and change the spring. PARTS LIST Part No. -
Page 6: Assembly Drawing
ASSEMBLY DRAWING... - Page 7 Note: This manual is only for your reference. Owing to the continuous improvement of the machine, changes may be made at any time without obligation on notice.