Gigabyte Z490 VISION D User Manual page 64

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Go to
Settings\IO Ports\SATA And RST Configuration, make sure SATA Controller(s) is enabled. To create RAID,
set SATA Mode Selection to Intel RST Premium With Intel Optane System Acceleration. Then save the
settings and restart your computer. (Figure 1) Note: When using a PCIe SSD, make sure to set the Use RST
Legacy OROM item under Settings\IO Ports\SATA And RST Configuration to Disabled and RST Control
PCIe Storage Devices to Manual. Then depending the M.2 connector you use, set the corresponding PCIe
Storage Dev on Port XX item to RST Controlled. Finally, save the settings and exit BIOS Setup. (If you want
to use NVMe PCIe SSDs to configure RAID, make sure to set NVMe RAID mode to Enabled.)
Step 2:
To use the EZ RAID feature, follow the steps in "C-1." To configure UEFI RAID, follow the steps in "C-2." To
enter the legacy RAID ROM, refer to "C-3" for more information. Finally, save the settings and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
Configuring a RAID Set
Figure 1
- 64 -